Financial Mistake--Team Droppin' Hz--'10 Taurus Trunk Wall--Oval box COMPLETED--Video added (5/30/16)--DC Audio, PRV, Crescendo

[sebringR/T]

Started wrapping the rest of the interior today, but had to stop shortly after I started to try and take care of my girls car. I rewrapped the drivers side handle cup and the driver's rear door top trim piece and then finally got the lower trim wrapped on both the front and rear drivers doors. Looks so much better now that they are finished. Still need to wrap the driver's rear door handle cup and then the rest of the passenger side stuff. Once I get to that point I will also be wrapping parts of my new sub box and some accent pieces on my amp as well.

[sebringR/T]

Went and worked on the box for a few hours today. Got the back/front baffle smoothed down and resined.

A

[sebringR/T]

Moar progress made today. Doesn't look like a lot, but actually was quite a bit of progress.

Getting all the ledges filled in on the top and bottom...

Shouldn't take too much to get them smoothed down. Might take a little bit of kitty hair to make it completely smooth.

[sebringR/T]

Buddy Trent got bored and went ahead and finished glassing one of the halves of the tube tonight. One less side I have to do tomorrow.

[sebringR/T]

Home stretch of the interior of the box.

[sebringR/T]

Not a whole lot got done today. Sanded down the previous layer of filler and laid hopefully the last layer of filler down to smooth everything out. Tomorrow I'll go back in and sand it down and then we should be ready to start work on getting the port in.

[3vil]

Looking real good so far, can't wait to see this enclosure when it's finished.

[sebringR/T]

Not a lot to update. Past couple days have been really busy so I haven't been able to do much work. Have the entire outside of the box resined and ready to be sanded down. Might take a touch of filler to some spots once that's done, but other than that we are ready to figure out exactly how deep we are gonna make the box and figure out what we are doing for the port design. Gonna take tomorrow off from it and start back on it Monday.

[sebringR/T]

Little bit more progress today. Worked on the outside of the box. Got almost everything sanded down and smoothed out. Probably going to need another layer of resin to help get everything smoothed out without using a bunch of filler.

[tboorn]

man looks killer, great idea for the box. im excited to see how it comes out