Need Port Help--rusty We Need Ur Help Too

[techaninna]

height 15.5 width 6 depth 18 according to his post

[techaninna]

same box, different front and adding strength

but that will only give me less then 2 inches from end of the port from rear of the box

Let me see what i can come up with

[loganberry]

Let me see what i can come up with

thanks, port noise is one of the problems i had before (not enuf space from back wall to port)

[EricM9104]

Dimensions, would draw up a box design but this computer won't run CAD or SketchUp at all.

Well, if someone could, draw up a design for the dimensions I specified.

[techaninna]

Ok i am assuming sub displacement is .2 per sub

15.5 high 5 wide 14 long

Should put you around 37 but remember that if it is a double baffle to subtract 1.5 (3/4 wood) from your port cut.

Edited May 11, 2008 by techaninna

[loganberry]

Ok i am assuming sub displacement is .2 per sub

15.5 high 5 wide 14 long

Should put you around 37 but remember that if it is a double baffle to subtract 1.5 (3/4 wood) from your port cut.

so it would only be 12.5 long?

[techaninna]

so it would only be 12.5 long?

Thats right cause if you add 12.5 plus .75 plus .75 equals 14 from the back to the front of the port.

I'm not being a smart ass just writing it out.

[loganberry]

Thats right cause if you add 12.5 plus .75 plus .75 equals 14 from the back to the front of the port.

I'm not being a smart ass just writing it out.

ill send alpine a pm with that info and see what he has to say

[techaninna]

ill send alpine a pm with that info and see what he has to say

Thats cool I use the worksheet calculator AMatt85 made

[loganberry]

Thats cool I use the worksheet calculator AMatt85 made

he said it sounds good!!! thanks guys