Jump to content
Sign in to follow this  
Mrbubbles00482

82 Cutlass Door Panels.

Recommended Posts

So I wasn't happy with my Kicker components or where my last door panel project was going. SO decided to start over.

I got some Rockfordfosgate Punch162s components today so I decided to start out by flushing the tweeters in the doors. I also picked up some 1/4th mdf for my base on my fiberglass pods for the 6 and a half.

Left door with tweeters flushed.

First time wrapping a door panel. creases up in the front by the tweeter because of the curve.

Posted Image

Posted Image

I got the base's cut and the mounting rings cut tonight but no pics. I'll have them up tomorrow when I build the inserts and decide whether the crossover will be visible or hidden behind the door.

Share this post


Link to post
Share on other sites

Ya I posted the last set I made over on FGF. I got the material from my local fabric store. Suede cloth, one side suede the other side a cotton composite, like 6 a yard or something like that.

I got the driver side 6.5 pod made and wrapped in cloth for fiberglass BUT I seem to have misplaced my MEKP hardener for it. =[ off to home depot.

Share this post


Link to post
Share on other sites

So I got the left panel glassed up. Im out of mixing quarts and brushes though so its off to the paint store....might as well pick up my paint while im there.

Posted Image

Screwed down to a 2x4 so it doesn't warp.

Posted Image

Glass

Posted Image

Posted Image

Share this post


Link to post
Share on other sites

Hmmm I like that 2x4 trick... so much so I think I have even used it in the past! :D Looking good man!

Share this post


Link to post
Share on other sites

So I got the second layer on the right panel, so all glassing is done.

I started body filling and then I come to find I only have one sheet of 36 left and nothing up untill 150 grit.

Back to home depot...again...

Hopefully the left door will be close to being done by tonight...and then the right door tomorrow before I go to work.

Pics later.

Share this post


Link to post
Share on other sites

Just some pics of progress...nothing special. Two layers of body filler down, all thats left on driver side pod are pin holes around the speaker ring, body fill the length, and finish sand.

Posted Image

Posted Image

Posted Image

Share this post


Link to post
Share on other sites
Sign in to follow this