lamchop_8 Posted November 19, 2008 Report Share Posted November 19, 2008 This Is My (Soon To Come) Setup Is It Good Or Not? SUB:(1) 18'' Fi.BTL (Fully Loaded):D2,Cooling,HiXm Coil,Induct Heat Ring,Daily Option. AMP:(Two) Hifonics Brutus BXi 2008D (2000 Rms @ 1ohm,Overrated So Maybe 1700 Or 1800 Rms @ 1ohm Total 3600 Rms & Fi.BTL's Are Recommended @ 2000 Rms) (4) Screws For Terminals (Better Solid Connection No Leaks) Enclosure:(1) [Ported] 8.6 Cuft. (After Displacemant) Tuned To 32hz. 3/4 MDF Will That Be Loud? Also How Deep Would It Get For One Sub With A Enclosure That Big? For A Lucky Quess Do You Think I'll Hit @ Leats 145db's If Not A Little Over? P.S:This Is My Budget So Please Dont Ask For Anything More Expensive I Appreciate You Reading This Message Please Answer Quote Very Very Soon 2 Come??? (1):2002 Chevy Blazer Xtreme (2-dr. with Sunroof) (4):15'' Orion Hcca's (1):Stetsom V 14K2D (6):Kicker PKD1 (Ampkit) Ported:14 Cuft. (After all displacements) Tuned to 34hz. 3/4 MDF (:Screws for terminals (Better solid connection no leaks) (1):Dynamat xtreme license plate kit (1):Kenwood eXcelon KDC-X492 (3):300amp HO Alternators (4):Kinetik HC 3800 Batts. (1)Rockford Fosgate Power T8004 (For Mids & Highs) (4)Rockford Fosgate Power T162S (Mids & Highs) (3):Kicker PKD4 Ampkit (For Mids & Highs) (1):Kinetik HC 1800 (under the hood or yellow top) (1):Viper 5701 (p/n 5202V) ALARM Big III will be done (beefing up my electrical system) etc. Goal:154.9db-159.5db Link to comment Share on other sites More sharing options...
Boon Posted November 19, 2008 Report Share Posted November 19, 2008 That box is probably too big for the power you're throwing around. And made of 3/4 MDF it'll flex like a cube of jello :/ Quote 10.x volts fo' life! Link to comment Share on other sites More sharing options...
raytard Posted November 19, 2008 Report Share Posted November 19, 2008 if youre planning on running that much power to it, drop the box size closer to 6cubes, or else youre gonna get some nice unloading and other things on lower notes, and by "nice" i mean "destructive" my .02 and it will def get loud and def get low, and depending on the vehicle and other factors (deadening, batteries, chargin system, orientation, etc) 145 is definately possible. Quote Build: http://www.stevemeadedesigns.com/board/ind...hl=avalon+build monster/rockford/kicker/stinger cables, pioneer source, jbl highs/amps, kinetik/shuriken batts, iraggi alt, dei security, dc subs(atleast for now) Team DC Link to comment Share on other sites More sharing options...
wL<3bass Posted November 20, 2008 Report Share Posted November 20, 2008 For the price your are paying for two of those amps you could just get a Kicker zx2500.1, Rockford t20001bd or t30001bd, sundown saz-3000d, etc. Quote Vehicle: 1997 S10 Blazer 4dr 4X4 Exterior: Rear End Bagged, Black Grill, Lifted 2" Amplifiers: Rockford Fosgate T8004 & T10001bd Batteries: 2 Stinger SPV35, Kinetik HC2400 Electrical: Big 3, DC Power 290amp Alternator w/ MLA at 15.5v Enclosure: 4.2 ft³ @ 33Hz 84sq.in. of port (20sq.in. per cube) Headunit: Eclipse CD3200 w/ 80G iPod Mids/Highs: Rockford T152s (a-pillars), Rockford T162s (doors) Subwoofers: 1 15" Fi BL Fully Loaded Wire: All 1/0g Kicker Hyperflex My YouTube Videos My Fiberglass A-Pillar Build My "Seamless" Looking Box Build My DD1508 T-Line Bandpass Build "Seamless" w/ Acrylic Windows (for '05 TrailBlazer) My Stealth 8" Fiberglass Build (for '05 TrailBlazer) My Build For A Friend's '08 Cobalt 15" BL Sealed Off From The Trunk My feedback/references... Link to comment Share on other sites More sharing options...
lamchop_8 Posted November 20, 2008 Author Report Share Posted November 20, 2008 Your Probaly Going To Think Im Crazy But What Exactly Do You Mean By "nice unloading and other things on lower notes" and by "nice" i mean "destructive" Please Here Me Out!!! Quote Very Very Soon 2 Come??? (1):2002 Chevy Blazer Xtreme (2-dr. with Sunroof) (4):15'' Orion Hcca's (1):Stetsom V 14K2D (6):Kicker PKD1 (Ampkit) Ported:14 Cuft. (After all displacements) Tuned to 34hz. 3/4 MDF (:Screws for terminals (Better solid connection no leaks) (1):Dynamat xtreme license plate kit (1):Kenwood eXcelon KDC-X492 (3):300amp HO Alternators (4):Kinetik HC 3800 Batts. (1)Rockford Fosgate Power T8004 (For Mids & Highs) (4)Rockford Fosgate Power T162S (Mids & Highs) (3):Kicker PKD4 Ampkit (For Mids & Highs) (1):Kinetik HC 1800 (under the hood or yellow top) (1):Viper 5701 (p/n 5202V) ALARM Big III will be done (beefing up my electrical system) etc. Goal:154.9db-159.5db Link to comment Share on other sites More sharing options...
wL<3bass Posted November 20, 2008 Report Share Posted November 20, 2008 Your Probaly Going To Think Im Crazy But What Exactly Do You Mean By "nice unloading and other things on lower notes" and by "nice" i mean "destructive"Please Here Me Out!!! The box is too large your sub will unload.... aka voicecoil will slam against the backplate.....aka it will bottom out destructively. Quote Vehicle: 1997 S10 Blazer 4dr 4X4 Exterior: Rear End Bagged, Black Grill, Lifted 2" Amplifiers: Rockford Fosgate T8004 & T10001bd Batteries: 2 Stinger SPV35, Kinetik HC2400 Electrical: Big 3, DC Power 290amp Alternator w/ MLA at 15.5v Enclosure: 4.2 ft³ @ 33Hz 84sq.in. of port (20sq.in. per cube) Headunit: Eclipse CD3200 w/ 80G iPod Mids/Highs: Rockford T152s (a-pillars), Rockford T162s (doors) Subwoofers: 1 15" Fi BL Fully Loaded Wire: All 1/0g Kicker Hyperflex My YouTube Videos My Fiberglass A-Pillar Build My "Seamless" Looking Box Build My DD1508 T-Line Bandpass Build "Seamless" w/ Acrylic Windows (for '05 TrailBlazer) My Stealth 8" Fiberglass Build (for '05 TrailBlazer) My Build For A Friend's '08 Cobalt 15" BL Sealed Off From The Trunk My feedback/references... Link to comment Share on other sites More sharing options...
raytard Posted November 20, 2008 Report Share Posted November 20, 2008 yea, sorry if i was unclear bad things happen if the box is too large, physical damage mostly. decrease the size closer to 6 and it should be fine, use a subsonic filter Quote Build: http://www.stevemeadedesigns.com/board/ind...hl=avalon+build monster/rockford/kicker/stinger cables, pioneer source, jbl highs/amps, kinetik/shuriken batts, iraggi alt, dei security, dc subs(atleast for now) Team DC Link to comment Share on other sites More sharing options...
lamchop_8 Posted November 20, 2008 Author Report Share Posted November 20, 2008 (edited) yea, sorry if i was unclearbad things happen if the box is too large, physical damage mostly. decrease the size closer to 6 and it should be fine, use a subsonic filter Okay Is It Possible That I Can Run Both Of Those Amps & Still Get A Decent 1 Ohm Load? Im Going To Get Everything Installed Professionally "Custom Sounds" Maybe. Now I Know Even If One Amp Is Off By A Lil It Will Kill My Sub But Cant The Audio Place Equal Them Out So It Wont Hurt My Sub? One More Thing Since Im Giving It Alot Of Power Will It Still Get As Deep And Loud In A 6 Cuft. Enclosure As It Would've If I Kept The 8.6 Cuft. Enclosure? P.S:If I Cant Use Both Amps To One Sub Can You Find Me A Amp Thats Just As Good That Puts Out That Same Amount Of Power If Not More? This Was The Total Of The 2 Amps: 638.12 (Shipping Included!) Edited November 20, 2008 by lamchop_8 Quote Very Very Soon 2 Come??? (1):2002 Chevy Blazer Xtreme (2-dr. with Sunroof) (4):15'' Orion Hcca's (1):Stetsom V 14K2D (6):Kicker PKD1 (Ampkit) Ported:14 Cuft. (After all displacements) Tuned to 34hz. 3/4 MDF (:Screws for terminals (Better solid connection no leaks) (1):Dynamat xtreme license plate kit (1):Kenwood eXcelon KDC-X492 (3):300amp HO Alternators (4):Kinetik HC 3800 Batts. (1)Rockford Fosgate Power T8004 (For Mids & Highs) (4)Rockford Fosgate Power T162S (Mids & Highs) (3):Kicker PKD4 Ampkit (For Mids & Highs) (1):Kinetik HC 1800 (under the hood or yellow top) (1):Viper 5701 (p/n 5202V) ALARM Big III will be done (beefing up my electrical system) etc. Goal:154.9db-159.5db Link to comment Share on other sites More sharing options...
dmanson Posted November 20, 2008 Report Share Posted November 20, 2008 Okay Is It Possible That I Can Run Both Of Those Amps & Still Get A Decent 1 Ohm Load? Im Going To Get Everything Installed Professionally "Custom Sounds" Maybe. Now I Know Even If One Amp Is Off By A Lil It Will Kill My Sub But Cant The Audio Place Equal Them Out So It Wont Hurt My Sub? One More Thing Since Im Giving It Alot Of Power Will It Still Get As Deep And Loud In A 6 Cuft. Enclosure As It Would've If I Kept The 8.6 Cuft. Enclosure? P.S:If I Cant Use Both Amps To One Sub Can You Find Me A Amp Thats Just As Good That Puts Out That Same Amount Of Power If Not More? This Was The Total Of The 2 Amps: 638.12 (Shipping Included!) if you make the enclosure around 6 cu ft you can tune to play low notes. yes the audio place can set the gains and all that so you wont kill your sub. as for getting one big amp for around $638, look around bro ........ or look into the AQ2200d ($379 shipped), Hifonics 2608d and many other for around $600 ....... Quote 2-DC 15XLM2 D.7s 1-DC 5K amp (1) XS Power D6500(UNDERHOOD) and (1) XS3000(REAR) 3 runs 1/0ga for power and 2 runs of 1/0ga for negative. (2)-RFT165s components, ...... 4 separate 1 inch tweetersRF T600-2(fronts) Punch 450.4(rear) Audiocontrol 3.1. DC power 260amp alternator w/MLA Module Link to comment Share on other sites More sharing options...
lamchop_8 Posted November 20, 2008 Author Report Share Posted November 20, 2008 if you make the enclosure around 6 cu ft you can tune to play low notes. yes the audio place can set the gains and all that so you wont kill your sub. as for getting one big amp for around $638, look around bro ........ or look into the AQ2200d ($379 shipped), Hifonics 2608d and many other for around $600 ....... I've Just Seen A New Amp Which Amp Is Better Two Hifonics Brutus BXi 2008d's http://www.sonicelectronix.com/item_12120_...+BXi+2008D.html Or One AudioQue 3500D http://www.audioque.com/aq/AQ3500D.htm Quote Very Very Soon 2 Come??? (1):2002 Chevy Blazer Xtreme (2-dr. with Sunroof) (4):15'' Orion Hcca's (1):Stetsom V 14K2D (6):Kicker PKD1 (Ampkit) Ported:14 Cuft. (After all displacements) Tuned to 34hz. 3/4 MDF (:Screws for terminals (Better solid connection no leaks) (1):Dynamat xtreme license plate kit (1):Kenwood eXcelon KDC-X492 (3):300amp HO Alternators (4):Kinetik HC 3800 Batts. (1)Rockford Fosgate Power T8004 (For Mids & Highs) (4)Rockford Fosgate Power T162S (Mids & Highs) (3):Kicker PKD4 Ampkit (For Mids & Highs) (1):Kinetik HC 1800 (under the hood or yellow top) (1):Viper 5701 (p/n 5202V) ALARM Big III will be done (beefing up my electrical system) etc. Goal:154.9db-159.5db Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.