Red-navi-916 Posted January 12, 2009 Report Posted January 12, 2009 (edited) i have these 2 amps TEK 50.2 i bought 2 from a friend for very cheap..i looked em up and it says it can be used for subs and for mids/highs.... keep in mind i barely just installed my first set up still kind of new to this.... i got a tricky question...to power it up can i just get a smaller wire most likely 8-gauge and connect it to my current amp then from that amp to the tek amp and then the same with the REM and i will just get a new ground...or would that be too "ghetto" or would it be better just to cross/bridge it? LMK... heres pix my good camera is dead so bear with me.. ^^ left to right 12v-REM-Ground Edited January 12, 2009 by Red-navi-916 Quote BUILDLOG http://www.stevemeadedesigns.com/board/ind...showtopic=61862 "98crewcab"Never a POS....just always "a work in progress" lol that's how we roll bitches!!! Your a lowlife kid. I bet your mother wants to kill herself for not swallowing your ass.
AI James Posted January 12, 2009 Report Posted January 12, 2009 it will work but its hella ghetto, and if one overloads could fuck up both Quote
Red-navi-916 Posted January 12, 2009 Author Report Posted January 12, 2009 okay. then i will probably just run it a different way..would the fuse rate matter.. one being 20 and the other being 2 40's? Quote BUILDLOG http://www.stevemeadedesigns.com/board/ind...showtopic=61862 "98crewcab"Never a POS....just always "a work in progress" lol that's how we roll bitches!!! Your a lowlife kid. I bet your mother wants to kill herself for not swallowing your ass.
uhoh_45 Posted January 12, 2009 Report Posted January 12, 2009 distro block is what your needing Quote R.I.P! (Nov-29-2009) 92 explorer - 4 Atomic Apxx 15s duel .7s - 4rth order bandpass wall -4 powerbass XA-3000D's - 16 8volt batts wired to 16 volts - (9+/9-) runs 0gauge - 152.3 Db @ 29hz BUILD LOG current build 97 chevy lumina4 - 1 Atomic Apx 18 - 6 cube slot port trunk sealed off - 1 powerbass XA-3000D - 2 optima G31s in spare tire18 1 run 1/0 lumina build log
Red-navi-916 Posted January 12, 2009 Author Report Posted January 12, 2009 ^ u think so? imma look in to it Quote BUILDLOG http://www.stevemeadedesigns.com/board/ind...showtopic=61862 "98crewcab"Never a POS....just always "a work in progress" lol that's how we roll bitches!!! Your a lowlife kid. I bet your mother wants to kill herself for not swallowing your ass.
AI James Posted January 12, 2009 Report Posted January 12, 2009 yea get a distro block, also amps usually dont have mismatched fuses Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.