T Line Woofers -and Help-

[Mosin]

I'm wanting to build (Try) a T-Line enclosure for a 8" woofer. I really have no reason why, just to see what all the hype is about.

What 8" woofers meet the criteria T/S parameter wise??

I would like to try a 8" CVR in a T-Line but not sure if its do-able.

Would anyone want to show me a design or help me design an enclosure??

My box skills kinda suck.

Thanks for any help!

[duct_tape123]

You can do it with a CVR, but it doesn't have the best parameters. You'll need a 6.25' line with 40in^2 of "port" area.

[Mosin]

You can do it with a CVR, but it doesn't have the best parameters. You'll need a 6.25' line with 40in^2 of "port" area.

See thats the thing I somewhat understand what your saying, then again I don't. Thats mostly where I need help at.

[duct_tape123]

Here, I hope this helps a little. If you need a cut list I can do that too, just give me a shout. The red line represents the "t-Line" and its 6.333ft long. The "port" is 4"x10" all the way along the "line." Those dimensions are using 3/4" MDF.

Edited January 15, 2009 by duct_tape123

[Airborne]

how about for two E8's? but 30 inches long

[duct_tape123]

Get me some specs on them. I need FS, QTS, and QMS. Do you want a design for two in the same box, or two seperate boxes?

[Airborne]

This is what I found

Re = 3.37 ohms (4 ohm nominal)

Fs = 34.9 hz

Qes = 0.5323

Qms = 6.93

Qts = 0.4943

Vas = 7.6 L

BL = 13.3 N/A

Mms = 127.7 grams

Cms = 162 um/N

Xmax = 12mm one-way linear (70% BL method)

Rated RMS Power = 200 watts

Depth = 4.25"

OD w/ gasket = 8 5/16"

Cut Out = 7"

[BigPimpin91]

QMS Less than 7

QTS Less than .40

FS Less than 35hz

[Airborne]

Get me some specs on them. I need FS, QTS, and QMS. Do you want a design for two in the same box, or two seperate boxes?

Could you do one for each? A single and double 8" enclosure?

[Mosin]

Thanks for the help with the design Duct_tape!!

But what is that box tuned at?? And it is for the CVR correct?? LOL

Thanks again.