I need help with svc 4 ohm?

[connersdad19]

i dont see why i take the time.

[rubbernutz1]

I have 4 powerbass 4xl 6.5s that are 4 ohm single voice coil....the amp i have is the audiopipe 2002 that is 300rmsx1 @ 4 ohm....

which is what i need to wire these speakers to i think in order to get them to see what this amp has to offer...

here is the stuff from the fosgate wire wizard and then i did a paint sketchup and just want to make sure these are the same....i am putting a pair in the front and rear doors of my blazer and this is the only way i know that it will work...but i am needing help...because the way this is setup is a lot of wires lol....

http://www.rockfordfosgate.com/rftech/woof...ohmSVC_4ohm.gif

or since its a two channel could i wire two speakers like this

http://www.rockfordfosgate.com/rftech/woof...ohmSVC_2ohm.gif

its not 1 ohm its 4 ohm on the picture..my bad...

thats not a 1ohm load in the pic.

[connersdad19]

thats not a 1ohm load in the pic.

wow really :censored: i put that it was suppose to be 4 ohm...either help or get out seriously why come back with that why not try to help...you wonder why people dont ask questions...because everyone expects everyone to already know...

[c_stud]

it could be done running the power off side A to negative side B just be extra work

[connersdad19]

it could be done running the power off side A to negative side B just be extra work

thanks for something helpful....

i found this...

http://a248.e.akamai.net/pix.crutchfield.c...C_4-ohm_2ch.jpg

if i run each set of speakers to its own channel it should work correct?

[Team_DC-Derrick]

http://www.the12volt.com/caraudio/woofer_c...mp;I=41#results

use that website for sub wiring please