byers319 Posted September 6, 2010 Report Share Posted September 6, 2010 A buddy and I are finally getting around to putting an amp on my door speakers (not stock) and we were debating on how to hook the speakers up to the amp. The amp will be in the trunk. So all the wires will be ran back to the amp. Then to actually put the amp on the speakers isnt all it takes is speaker wire from the amp to the speakers and take the old wiring off? or is there something else were missing? thanks in advance.. sorry for noob question Link to comment Share on other sites More sharing options...
memphisBred Posted September 6, 2010 Report Share Posted September 6, 2010 Speaker wires from new speakers to amp is all you have to do. And of course power, ground, remote, and rca's to amp SMD Super Seller/Buyer Audison----Hertz----Rainbow Link to comment Share on other sites More sharing options...
byers319 Posted September 6, 2010 Author Report Share Posted September 6, 2010 Speaker wires from new speakers to amp is all you have to do. And of course power, ground, remote, and rca's to amp do i hook up the speaker wire thats always been there back up to the hu or just the two (pos neg)to the amp? Link to comment Share on other sites More sharing options...
memphisBred Posted September 6, 2010 Report Share Posted September 6, 2010 You don't néed the H/U wires. Just remove them from the speakers and put some electrical tape around the ends. Pos wire from speaker to pos on amp and neg of speaker to neg on amp. SMD Super Seller/Buyer Audison----Hertz----Rainbow Link to comment Share on other sites More sharing options...
byers319 Posted September 6, 2010 Author Report Share Posted September 6, 2010 You don't néed the H/U wires. Just remove them from the speakers and put some electrical tape around the ends. Pos wire from speaker to pos on amp and neg of speaker to neg on amp. thats what i thought thanks! didnt want to mess up $100+ Link to comment Share on other sites More sharing options...
Freshman6969 Posted September 6, 2010 Report Share Posted September 6, 2010 Speaker wires from new speakers to amp is all you have to do. And of course power, ground, remote, and rca's to amp x2 wiring though the boot is a bitch, but by the time you get to the 3rd door you get the hang of it Legal TL scores145.6 on the dash sealed up in the low 40hz area with the port out145.5 on the dash sealed up @30hz with the port inless then 1k clamped on a 3.5k! Why would you EVER WANT flex?huh?...flex is what can make the lows lower and more air being pushed correct? My FeedbackJeep-BuildlogPT LOSER buildlog Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.