can it be done?

[knowledge]

i have 6 12 inch subs, 2 of witch are single 4 ohms, and the other 4 are dual 4 ohms.

my question is, can this be wired to either 2 ohms or 1 ohm? if not what can it be wired to

[FreekDesignz]

i have 6 12 inch subs, 2 of witch are single 4 ohms, and the other 4 are dual 4 ohms.

my question is, can this be wired to either 2 ohms or 1 ohm? if not what can it be wired to

you should save up money and get 2 more D4ohm

[FreekDesignz]

you could mess around with this

[FreekDesignz]

^

[RickyFriery97]

you can wire the two SVC 4 ohm in parallel to get a 2 ohm load for those two speakers then you could wire the 4 DVC 4 ohm subs in series/parallel to get those four at a 2 ohm load

would be better if you had 6 DVC though

i would just forget about the SVC and just run the 4 DVC 4 ohm

[knowledge]

if done that way can can they all be wired?

[KnockinthaStreetzof608]

i thoughed it was a good idea to run two differnt subs??? doesnt one sub suck the juice of the other 1?

[RickyFriery97]

The two SVC subs will be wired separately from the 4 DVC but if wired right you can get both sets of subs to a 2 ohm load but I wouldnt recommend it