mrwigglezdj

that was off 3 funkin audio MF400's at 2ohm they are rated at 600watts rms at 2ohm and defentaly do their power

i wish they were power series i would keep them so i can have 4 power 6.5s along with the tweets but they are the punch seires, i bought them off ebay without completly reading the discription and got them and bam they were punch, not that there is anything wrong with punch i just prefer power o and yes they are componets

same here but it played a few mins ago so its prolly a bandwidth thing

:^ lol ill be dam sure not to try and pull that stunt off

ok ill take the first 110 for these things :-[

not much you can do with 6 batterys 7 amps and only a 50 amp alt lol

well when i began the bass boxing match i peaked at 152.1 and as the 60 seconds went by my total aveage was 148.7

with 160 amps and depening on your total system draw you should good ad the extra battery it wont hurt since you have more than a 90 amp alt

i wouldnt so much worrie about the cap but the battery will help some but if your alt is already strained you realy should conisder investing into a high out put alt to solve all your power issues, think of the cost of the cap (averages 100-150 in audio shops) and a battery (50-150 depening on the battery you bought) that can be as much as 300 dollars in cap and battery when a high output alt only cost 350-450 and is gaurnted to solve the power issues instead of just patchin the issues and then have them come about all over again at a later time

have any money? make a offer if you have any you might get surprised

:^ lol amen to that one, it can be done with a frost vinyl decal or it can be done via cnc machineing which wont fall off from excessive heat and whatnot

ok i have a brand new in the box set of rockfordfosgate 6.5 componets heres the specs on them * Unique Twin Drive Technology with Four Independent Tweeters * Mount Tweeters Coaxially, Separately, Or In Combination * 3/4" Aluminum Dome Tweeters with Swivel Mount * Compact 12 dB / Octave Outboard Crossover * Mica Injected Polypropylene Midbass Cone * Polyurethane Midbass Surround * Cold-Rolled Steel Basket * Removable Magnet Cover * Grille with Integrated Screw Concealing Ring * Removable Midbass Phase Plug * Size: 6 1/2 * Sensitivity: 88 dB * Frequency Response: 60-22,000 Hz * Recommended RMS Power: 60W * Peak Power Handling: 120W * Impedance: 4 ohms Shipping: 8.25lbs selling them for 145 shiping included in price

ill take them if you havent sold them already,send me a invoice via paypal to [email protected] zip code is 32583

how do i test or tell the resitors are good or bad?

i dont have any questions, the pictures tell the whole story and i love it detail in the whole box design , esp the resin 45's thats pimp :^ and the changeable port is awsome as well :-* i will defentaly burrow a few of the methods used in this box when i beggin rebuilding my wall (and ill take pics of the demo and rebuild of my box as well for all to see) im hopein to fit 20 10's and 8 6.5s with 4 horns in my new wall and have it carpetd or finished in some fashion or another ...but meade you rule and so does your boxes =V^

well i sold the ones i had but if you want some let me know i can get brand new amps with factory warrnety as well but the price will be a little bit higher i cant internet challenge the prices found online but the o2 i got special from o2 to run in my van for a few shows , but i can get the poweracoustik a3000DB whcih is exactly the same amp for 350 each, or the kole qxi3000D which is also the same thing for 340 each

1000w rms at 4 1800 rms at 2 and 2300 rms at 1 and they do very close to the rated power i might add, very nice amps for the money i gave for them and there strapable and did a little test on one at 12 v car off i disconected the speaker wires and did a 55hz tone at 3/4 volume on my head unit and it put out 62.3 volts and at 16 volt power the amp dod 73.9 volts at the same volume level

well if you dont mind spliceing and tapeing i have alot of scrap that just came out of my van i can make 75 feet lol

i would have to say double check your ground on the high amp, and do a meeter test on the voltage at the amp, sounds like youre loosen power .... with yours i would have to guess that the amp is cliping, and or you have the sub wired too low for the amp then thus the protection light comes on, so double check what ohmage youre runnin and make sure your amps is stable at that ohm and if you havent properly set the gains on youre amp you need to properly do it before you blow a sub(s) or burn up a amp

i have aprox 15-17 feet of 2/0 but its not fosgates its funkin audios hyper stream wire very flexable with a high strand count (dont know the exact number but after stripin and crimpn the shit ive come to notice how much is inside the jacket lol)

wonder if i can do a hair trick with my van........ 12 10's in a wall.... i need to find me a great big fat girl with long hair either on her head or legs to be my hair trick chick and try my own hair trick, and i say fat girl because you wont find no fine girl in or near my van lol theyd be too worried they would need a tetnis shot or something from the rust and jagged edges on the beater

:^ SOLD mofo's

thanks, i thought my model number was 1rf3205 but i just did a online chat with a company and found out the model number is IRF3205 and they have them cheap so i bought 10 on the spot hope it works and i salvage my amp :'(

:'( well i was wangn on my way to work and around town today putn the heat to my subs, when all of a sudden my shit when into a solid 60hz burp when i was playn 504 boyz, i was like what the fuck, stoped and ran my ass to the back of the van poped open the door only to see a cloud of smoke comen from one of my amps....so i rip out the amp cusn and bitchn the whole time, i tear the thing down and it stinks like shit and i can only find 1 mosfet thats chared so none the less i need to find somewhere that sells mosfets, i need 8 that carry the model number 1RF3205 i say 8 because ill just replace them all to be safe, and one other question is would any mosfet work or does it have to be the same? i can get one at raido shack but its a diff model number and all that so i dont know if it will work or not

Kinetik was at nopi this past weekend and i finaly got to play with a few of their batterys and wow, i was majorly impressed, i run 6 interstate 12v workaholicks and during a burp i go down to 9.5-10 volt (50 amp stock alt) and with just one of the kinetiks 2400 in the back running all 6 of my amp i only droped down to 10.75-11 volts a big increase in voltage i can only imagine what my voltage would be if i had 4 of them in my van , batcap on the other hand didnt feel like comeing to nopi for one reason or another?....go figure so i can only offer my opinion on kinetiks :^