crf450r4u2nv

why not wire it in pairs ? you could still fade if you wire the front 2 pairs to the front two mids in the door. and then make the rear mid of the front door and the back seat mid a pair. that amp would be happy and each mid would see more clean power. unless you were going to use auto time delay corection of some kind like imprint.

this is not right. a d5100 should be able to power that system alone with truck off for a good awhile. what does your voltage look like at batt before you start to wang ?

i bet it pounds now, congrats !!

wouldn't volt x amps = watts work in all cases regardless of ohms of coarse with rms dmm's

so did it even get warm ?

i would try to run just the d3100. un hook the diehards if you are running at 14.8v, then your resting volts should be higher13.5-13.8 on the d3100. you should check each connection front to back, solder if possible. i am going to presume that you have the big three done from when you put in your alt. bigger pully on an irragi alt doesn't sound right, don't they have a hard time at idle already, bigger pully would make it turn even slower. <i don't own one or know anything about irragi> and like was already said by someone else go wang on it and check volt drop at amp them at d3100 then at front batts the diehards then at alt terminal and post back. and is this drop happening at will with hard wanging or only over long periods of hard wanging ? and do you ever dive without wide open wanging to recharge? and when you drop to 11 volts how long will it take to recover ? enough questions good luck, you will get it

well is anyone saying that it so bad that if you were say at the other side of the shopping mall inside a building full of electronics and stuff and walls that this alarm is NOT likely to work reliably ??? just tryingto gauge worst case are we talking 100 ft ---100yards----1/4mi talking proper install, city type interferance, dinner out, movies, shopping, work ??? thanks for your opinions.

how far are you getting real world ??? i ask because this is the alarm i want for my explorer. at work i am about 1/4 mi away. i never figured that it would work at 1 mi but had hoped for 1/2 mi.

you don't have to drill holes in floor if you flip up the back seats there is a set of rubber grommets the size of your fist right by the frame nice and clean

so how did that go ?

why is that?

the more you add of any size mixed and matched will help. if you are worried unhook all batts from all wires and come back next day and check all batts seperatly for voltage. if they are close your fine. hook it all back up and wang

i don't have an answer for you, but i run wet cell deep cycle batts in my boat and they get regularly disscharged the most i ever get out of them is 2 years i run the same in my jeep cherokee with very seldom disscharged and get atleast 5 years i only used agm batts in my boat once they died in the first year they were optima and got replaced with wet cells again i don't know if it was a fluke or if agm don't deep cycle like wet cells all that said i want to know too because i am thinking powermaster for my explorer

resting volt is what matters the most so if your resting volts are about the same you will be fine even if they are not the same you will be ok but when you park your lowest volt batts will try to pull the voltage of the other bateries down to its voltage. not dead but down to the lowest voltage batt . so you can mix any ma batt you want as long as the voltage matches. this is because in car audio we conect them in parralell. if we used them in series like in rc car usage the voltage can varry but the ma must be the same or when being disscharged if the ma varries too much, the batt with the lowest ma will run out before the other batts and then actualy have its charge reversed<verry bad for its life span> then when charged the low batt wont fully charge then when discharged again it runs out even sooner and reverses even harder doing even more damage. batts in series are only as strong as there weakest link . this came out pretty convoluted <long night at work> if you need me to put it into english i will try

do you sell brackets to hang this as a second alt on a 2000 explorer xlt v6