MrBalll

MrBalll

They are on the back of the HDD. There should be a diagram on the HDD to tell you how to set them.

Same as what above poster said. Great system.

Computers and guns.

I would have to recommend this website as well. That is where I spend most of my time and rather than regurgitating OC'ing information I would just recommend going there and looking for the guide. It will be in the Intel section of the website.

Congrats, Steve.

Yeah, pretty much just worried about flexing mainly being I will need to mount my amp on the backside of the box. The side that will face the front of the vehicle so I knew that's it's already frowned upon but if you are going to do it make sure the box is braced well enough to where it won't have too much impact on the amp. I appreciate all the help with this, uhoh. Looks like I have all that I need to make my box now.

Awesome, I appreciate it, uhoh. One more little question. The width on the port is huge. So it would pretty much be your image only with a much longer port opening and subs upward? Would that cause any structure problem since it will basically be the entire length of that wall? Or will I just need to put one or two two inch long braces along that wall?

Thanks for the help, uhoh_45. If the problem is the box measurements I could go to 48" width x 34" depth and if really needed 26" height. Would that make a big difference?

See, that's one thing I still don't quite get is the tuning. If I am going for both sound quality and a loud sound, more so quality, would I want to tune it to around 35 or 36?

Edit: new measurements in post 5. Little background. I listen to Hip-Hop/Rap and the occasional Rock-n-Roll. When I listen to the Rock I plan to use a remote EQ to turn the subs way down or completely off. I currently drive an 04 Tahoe and I will have the port facing the lift gate and the subs facing upwards. Ok, I have been trying to use the Speaker Box Tuning utility and I thought I had it all worked out but I can't get the port worked out. I will hopefully have two AA 18" Chaos subs in a ported box. Since this will be a daily driver I assume I want 40 Hz for the tuning? This is what I have so far. The subs call for 6-10 CF each for ported so I figure after the port walls and sub displacement 18 CF should work out fine. I assume that the front of the box does not count as a common wall so I only put two in there, top and bottom. Wasn't too sure on this part, but this is idea I have so far. So, really all I need is an idea as to what I should tune it to as well as help filling in the middle and bottom section of the Tuning utility. So how long/wide I need to make the port walls and opening and if I even need those extra pieces that are behind the subs or if I just need a straight wall and that's it. If I do need those pieces behind the subs how long should they be? Thanks for any help, MrBalll

Look very nice. Great job on the install.

Very nice looking gun. I ended up going with the 500 and I love it, so I'm sure you will like the 870.