g2shuck

Still trying to figure out a interchange slot port for daily and burping but at least I know this will work for daily and demos

My god

Sneaky rusty changed his post on me lol

Also thinking about a 7.5 x 14.5 oval adjustable psycho port. That would give me 85.41 inches of port.

I am also interested in this. Will Steve sell just the case that comes with the 3 piece set?

I am workingon the design for my two new ar coned xl 15s. Power will be a dc 7.5k. I am very tight on space since its a sealed trunk build with a rear battery bank. I wanted to do aeros so I could have ports for daily and for burping, but could only fit two 6 inch aeros on the baffle which I do not feel is enough so have worked on a design with a slot port. Since I am overpowering them how is this design?

I need one now lol

Rusty does not make the neo anymore. Level 6 is the strongest but is only offered in an 18 inch standard beow that is level 5 which is a monster also.

which vehicle?

3rd same topic just reworded? not good on this forum man

3500 is doible rated so better know what ur doin

I am at work so do not have Torres till I get home but here are some rough numbers based off calculations. What do you guys think? 16.76 Gross Volume 2.63 Port Displacement 14.13 Net Volume 28 Hertz Tuning Top Slot Port 5.75 Inches Tall x 45 Inches Wide x 17.58 Inches Long 258.75 Square Inches Of Port 18.31 Square Inches Of Port Per Cubic Feet Of Net Volume

im going to be tuning to 30 hz kyle

How the hell can I make an interchangble port if the port is 3 common walls lol. Then I could test both 250 sqaure inches and the 15 inches per foot on my TL.

I will be between 19-20 inches per foot with 250 square inches and 13 cubes net. Sound ok?

When I ran my two dc level 4 12a I had 72 square inches of port, and they sounded great and where no peaky. They have 23.5 mm of xmax. That calculator says they need 82.39 inches. So I was running roughly 15 percent less port area than that calculator says to and loved it. So if i do 250 square inches this time I will be about 17 percent less than the calculator. I think that will work out great on 5k clamped per sub with drivers side ported wall.

If it makes a difference I am hoping to clmap very close to 5k per sub after impedence rise. Wiring amps low lol.

I will probably end up with around 250 square inches of port for my 13 cubes net. So around 20 incher per foot.

I knew that is was not box dependent which is why I was not happy to keep getting told 15 per foot. According to that claculator I need 300 inches for the two 18s with 32.5mm xmax tuned to 30 hz. WAY more than 15 per foot lol.

I keep getting told to stay around 15 square inches of port for cubic feet which I have always done in the past, but is there not a formula to find port area based off sd and xmax? I am doing a wall with two level 6 m3 18s and 15 inches per foot would be around 200 sqaure inches of port for 12 cubes net. To me that just seams really low for two 18 with 32.5mm xmax and 1217cm² sd.

2 ftw

We have a shop that just opened close that carries sundown. I have to agree it is nice to see a shop push something besides kicker and alpine

Can't the Dyno be used in car also? Just big to carry around of course lol

Lol I was thinking Kyle of the other dc

Hell ya cody. I will need a cc-1 soon enough.