How do I wire 2 3ohm scv w7's?

[MarcoCaparrotta]

Hey everyone, I just bought 2 12" jlw7's. They are each SVC 3ohm. I was told there is no way to connect them to my amp without frying it. my amp is a kicker zx750.1, 750watts at 2ohms. Please help me out yall, will it fry my amp? thanks.

[MrSkippyJ]

a mono amp that isn't 1ohm stable?

[Louisiana Bass]

Kickers new amps are only stable down to 2 ohms

[MarcoCaparrotta]

Kickers new amps are only stable down to 2 ohms

so there is no way in hell that I can run these subs on my amp?

[vettedude102]

6 ohms wiring them in series

Edited July 18, 2011 by vettedude102

[MrSkippyJ]

Kickers new amps are only stable down to 2 ohms

LAME

so there is no way in hell that I can run these subs on my amp?

you can try it in parallel, it's 1.5 ohms. I don't know much about kicker amps so I have no idea what it might do. I wouldn't really recommend it if it were me though.

Edited July 18, 2011 by MrSkippyJ

[MarcoCaparrotta]

6 ohms

if its at 6 ohms, my amp will run fine? will it still put out the full 750 watts?

[RickyFriery97]

You can wire down to 1.5 ohm, you could try, after rise you could be alright but don't count on it to save you, I've seen some zx series amps ran @ 1 ohm.

[6berry]

you can wire them down to 1.5 ohms which could be safe, could cause problems. i doubt the difference between 1.5 and 2 would be a problem though

[fox_racin4]

I say try 1.5... it should be fine