Two level 6 12s! Tensile problems :(

[OrionStang]

Common port walls should be "1".

That pic is tiny as hell BTW.

[lolitskasey]

Yeah I saw that I will re size it when I get back to my desk on my lunch break

Edit: so since I will have two bends cause I want my port to be in the middle of the box would I want to cut the total length of the port in half? Example, the port length is 31 would I cut that in half to make two bends? Sorry if that didn't make any since its hard to explain. On my lunch break I will make a visual.

Edited April 24, 2013 by lolitskasey

[OrionStang]

Visual would be good. I was assuming the port was along the bottom facing back. If the port is vertical in the center, leave the common walls at "2".

Ill do a quick sketch of how your port should look.

[OrionStang]

View from the top. You don't cut the length in half, but the width of the port is halved.

[lolitskasey]

Thats was i was trying to verify. so both bends would be, 18" long and do the 90 9 7/8?

[OrionStang]

Yes. Unless somebody see's I'm doing something wrong

[lolitskasey]

EDIT: Tweaked my box design a little bit and made up a little visual how does everything look?

Edited April 29, 2013 by lolitskasey

[lolitskasey]

Some updates, it was a amazing day outside for once. I got all my power wire cut and soldered to length. I also bought a new AGM bat for under my hood.

[lolitskasey]

Got some work done yesterday ran my power, going to run my grounds today and start on my box.

[SnowDrifter]

That's a healthy amount of wire