boogie0410 Posted August 24, 2012 Report Share Posted August 24, 2012 I have a s10 and I was thinking about going with four tens in a blow through,I can go 39"x16"x36",not really sure on the tens yet,but was looking at dcons,cheap,and will be a good start for my budget Link to comment Share on other sites More sharing options...
Ambassador of Bass Posted August 24, 2012 Report Share Posted August 24, 2012 That sounds like a nice build...try looking into RE audio too i have had good luck with them too...if you arent set on 4 10s maybe do 2 or 3 more powerful 12's? idk either way that is gonna b loud. Audi A6 Quattro Wangin' Wagon Pioneer Premier DEH-P5901B Headunit w/ IPOD control American Bass SQ5.25 in the Doors Compression Drivers and Horns under Dash 2 American Bass SQ475's for Mids/Highs4 American Bass HD 15's American Bass 500.1 17cuft 3/4" Double Baffle Birch Enclosure 240sqin port @38hz1/0 AWG Stinger big 3 under hood4 Runs of 1/0 AWG Stinger Power and Grounds Stinger Fuseblocks(3) XS Power D3100 Powercells120 amp AlternatorBlue Streetglow Underglow and Interior with Music InterfaceEscort Passport 8500 X50 HardwiredScanGuage II with voltage Readout Link to comment Share on other sites More sharing options...
Socky Posted August 24, 2012 Report Share Posted August 24, 2012 sounds like a plan, always to build it really nice, and just swap subs to upgrade down the road. Jeep Cherokee 4dr -4.75 in front, new rusty's 4.5 in rear leafs -micky thompson 35x14.50x15 -locker rear -Rusty's offroad Engine/transmission/transfer case/crossmember/gas tank skid plates -Warn front bumper with 8000lb winch -Custom rear bumper -Warrior product tube doors (summertime) -Optima redtop (starter) -26XK miles and still runs like a bat out of hell Kenwood H/U 1/0 wire, 136 amp alt 200 ah batteries 12.7 daily 2 Apsm 1500 @ 2 ohm strapped on zv3 d1 with ns softparts Mb quart 125.4 wired to 4 aura 6's 3.6 cube box tuned to 36 plays down to 23hz Link to comment Share on other sites More sharing options...
ToNasty Posted August 24, 2012 Report Share Posted August 24, 2012 Will be very loud. My s10 had 2 12"s in a forward facing box. With so little room your sphincter is gonna rattle ***Super Sellers List***http://www.stevemeadedesigns.com/board/topic/25829-super-sellers-buyers Link to comment Share on other sites More sharing options...
boogie0410 Posted August 24, 2012 Author Report Share Posted August 24, 2012 Im not set on anything yet but here is my question, how would I build this? I figured out that if I made 45s on two them and 22.5 on the other two (degrees), that it would leave me about 5 9/16 for a port,how would I tune this,or does anybody have any other ideas. Link to comment Share on other sites More sharing options...
boogie0410 Posted August 25, 2012 Author Report Share Posted August 25, 2012 Also what about a 4th order? Link to comment Share on other sites More sharing options...
boogie0410 Posted August 26, 2012 Author Report Share Posted August 26, 2012 So I was reading that for a fourth order you need it to be 2 to 1 does this mean that the ported side needs to be twice as big as the sealed side? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.