How much power to the mids and highs t1675-s

[Smoove]

Now that I have picked my door speakers 3 sets of T1675-s. I have yet to pick an amp to drive them. The blowthrough will be about 4800wrms on 2 DC 15 XL's. So I figure 3 sets of components in the doors of my c1500 ext cab truck should keep up pretty well.

I plan to use the passive crossovers. So I am looking at 3 brands (not gonna list them-just the wattage) amp all 4 channel. So I will need 2 4 channel amps.

T1675-s 100rms

1 channel to each crossover

75wrms per channel

100wrms per channel

or push the fosgates a little and go

120rms per channel

Yes, each wattage is a different brand amp and I don't wanna make this a VS, more of a how much will the fosgates take, and will it be enough to keep up with the subs.

[Sonic]

I would give them 150 rms per side using the passive crossover.

With a ZED Audio Leviathan 3 amp.

[tdsa23]

Im putting 110Watts to mines with the crossovers, and the crossovers take away some power but they still get really loud

[Smoove]

which components are you guys running?

[tdsa23]

RF T1s

[Smoove]

RF T1s

So pretty much the same ones I will be running. Good to know they will take that kind of power.

[Sonic]

Yep, the t1's on passives takes the power.

[Smoove]

Damn, now I have to start thinking bigger. How are everyones T1's sounding on amps at more than 120rms per channel on passive crossovers. this is the first time I will be running fosgate components.

[Watch the bass]

Did you want to use your 3 set´s in the door´s? Or is it 2 for the door´s and 1 for the rear. If it option 2 you have the possiblilty to run it on a strong 2 Ohm stable

4 channel amp. Set 1+2 @ 2 Ohm in the door´s on channel 1+2 and the rear on channel 3+4 on 4 Ohm´s.

[Smoove]

I was planning 2 4 channel amps. 1 to feed the 2 of 3 sets in the doors and another 1 to run the 3rd set in the doors and the 4x6's for rear fill. all @ 4ohm per channel