3 subs 2 amps wiring configuration

[tefik95bass]

I have a buddy at school who didn't think his system out too well. But he's running 3 sa 12s on one hifonics brz1200, he has another amp waiting to be installed, but I can't seem to find a wiring configuration.

[Watch the bass]

Another Brz1200!? Strap them Master>Slave and use the wiring wizard to get the Ohm load that you want http://www.rockfordfosgate.com/rftech/woofer_wizard.asp

[Noel989]

Get a third and run one to each

Are d2 or d4 you can strap the amps and run them at 2.34 if their d4

Or if their d2 run it at 1.33 but most amp are not stable below 2 ohms strap

Or get get a 4th sub and run a pair to each amp

[mbdblue]

Running 2 different amps to the same subs is a bad idea, unless its 2 of the same amp and they can be strapped to run all 3. Edit: the same amp or a different one?

[tefik95bass]

Are the hifonics amps linkable, subs are d2 btw

[Noel989]

I'm not sure but they should be but wiring 3 d2 gives you 1.33 or 3 ohms

And I've never seen any linkable amp that are stable below 2

[tefik95bass]

Running 2 different amps to the same subs is a bad idea, unless its 2 of the same amp and they can be strapped to run all 3. Edit: the same amp or a different one?

Same amp.

[tefik95bass]

I'm not sure but they should be but wiring 3 d2 gives you 1.33 or 3 ohms

And I've never seen any linkable amp that are stable below 2

So you're saying the SPL guys who strap huge amps can't go below 2 ohms? I dont understand.

But they curenntly are at 1.33 on one amp.

[Noel989]

I never said anything about not being able

They also do alot of testing and have the electrical to back it up

How's his electrical?

[Noel989]

Do you have the manual it should say their how to strap the amp