smd dd-1

[Jessica]

I really wish I had someone close to me that knows how to adjust this for me. No stereo shop here knows proper adjusting. They don't believe in a dd-1. They don't even know what its for.

We can help you, but you have to do like we say. I own a dd-1 as do many users here. We just need to go step by step. Do we need to start over and check wiring? I have seen a lot of guys just mess up including myself and wire one sub out of phase and output drops off drastically.

[CstrokerV]

I really wish I had someone close to me that knows how to adjust this for me. No stereo shop here knows proper adjusting. They don't believe in a dd-1. They don't even know what its for.

We can help you, but you have to do like we say. I own a dd-1 as do many users here. We just need to go step by step. Do we need to start over and check wiring? I have seen a lot of guys just mess up including myself and wire one sub out of phase and output drops off drastically.

yeah phase could be the problem ....

wiring 4 subs and being in a hurry could of mixed one up

Edited October 1, 2013 by CstrokerV

[Soccerballzs]

Every tweeter in my system has a 1.5 fuse to protect from blowing. Cheaper to replace a 1.5 amp fuse then to replace tweeters all the time. Install on the positive side of speaker wire, before your crossover.

Edited October 1, 2013 by Soccerballzs

[christamez80]

Put eq back to flat. Subs are wired correct. Psi helped me out to wire them. They verified it was correct. They asked for my whole setup and said everything I had was more than enough for the subs.

[CstrokerV]

still recheck the sub wiring like i said wiring 4 subs even with help you might of miss something

wheres your sublevel on your deck at?

Edited October 1, 2013 by CstrokerV

[christamez80]

Sublevel is all the way up. No bass boost on amp or deck. Source level normal and eq flat. Just double checked subs and they are fine. Checked ohm load and it reads 1.8 to 2.2 ohms on dmm for all 4 hooked up.

[CstrokerV]

no you have to physically look at how they are wired to make sure one or more isn't out of phase

Edited October 1, 2013 by CstrokerV

[christamez80]

I pulled the subs out and double checked. They are wired right. Let draw a pic to show how there are hooked up. they are wire parallel then wired in a series.

[christamez80]

[CstrokerV]

it looks right but im to tired to focus at the moment... and personally i would of series the coils parralel a set and then series again lol but like i said im having a hard time focusing lol