fx4trucker Posted February 23, 2014 Report Share Posted February 23, 2014 is the RE XXX 15 a ground pounder or SQ sub ?.. it hits but not what I was expecting . it does sound really good .. set up - the box is about 4.88 after displacements and port tuned to 32hz. I have a Memphis mojo 2500 watt amp on it. going off specs the box is a tad big so I was planning on fixing that soon witch will change the port tune to 34hz alpine head unit (freebee 2009 model)2 sets of eclpise 5.25 comp. speakers. 1. set is in the a-pilors 1. memphis mojo 2500 watt amp 1. rockford fosgate t2 15" dual 2 ohm wired to 4 ohm . seeing 600 watts 1. realm audio 600 watt 4ch Link to comment Share on other sites More sharing options...
CleanSierra Posted February 23, 2014 Report Share Posted February 23, 2014 How much port area did you give it? That sub has 54MM of one way linear excursion and needs some serious port. It is an SQ sub though and is a low end monster. Im not the one you want to try to troll. Just a fyi for you. Link to comment Share on other sites More sharing options...
kirill007 Posted February 23, 2014 Report Share Posted February 23, 2014 Just so you know, the RE XXX is designed to be used in a sealed enclosure that's why it has so much xmax. It should be close to a SQ subwoofer, but it still can be very loud. Thinking is the root of all problems... You ALWAYS get what you pay for. Link to comment Share on other sites More sharing options...
fx4trucker Posted February 25, 2014 Author Report Share Posted February 25, 2014 The port is 5x7x14 ..box is over 5cuft 4.88cuft after displacement alpine head unit (freebee 2009 model)2 sets of eclpise 5.25 comp. speakers. 1. set is in the a-pilors 1. memphis mojo 2500 watt amp 1. rockford fosgate t2 15" dual 2 ohm wired to 4 ohm . seeing 600 watts 1. realm audio 600 watt 4ch Link to comment Share on other sites More sharing options...
Guest Posted February 25, 2014 Report Share Posted February 25, 2014 35sqin of port? 5" tall by 7" wide? you might as well have no port area whatsoever with that small a port. Link to comment Share on other sites More sharing options...
Socky Posted February 25, 2014 Report Share Posted February 25, 2014 need more port, id say about 70sq in maybe more. Jeep Cherokee 4dr -4.75 in front, new rusty's 4.5 in rear leafs -micky thompson 35x14.50x15 -locker rear -Rusty's offroad Engine/transmission/transfer case/crossmember/gas tank skid plates -Warn front bumper with 8000lb winch -Custom rear bumper -Warrior product tube doors (summertime) -Optima redtop (starter) -26XK miles and still runs like a bat out of hell Kenwood H/U 1/0 wire, 136 amp alt 200 ah batteries 12.7 daily 2 Apsm 1500 @ 2 ohm strapped on zv3 d1 with ns softparts Mb quart 125.4 wired to 4 aura 6's 3.6 cube box tuned to 36 plays down to 23hz Link to comment Share on other sites More sharing options...
fx4trucker Posted February 25, 2014 Author Report Share Posted February 25, 2014 What about just doing a sealed box ? alpine head unit (freebee 2009 model)2 sets of eclpise 5.25 comp. speakers. 1. set is in the a-pilors 1. memphis mojo 2500 watt amp 1. rockford fosgate t2 15" dual 2 ohm wired to 4 ohm . seeing 600 watts 1. realm audio 600 watt 4ch Link to comment Share on other sites More sharing options...
kirill007 Posted February 28, 2014 Report Share Posted February 28, 2014 It will do just fine in a sealed box, it will be very loud for a sealed box because of the high xmax. Thinking is the root of all problems... You ALWAYS get what you pay for. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.