evermaxx Posted July 12, 2014 Report Posted July 12, 2014 Amp. Run it and burn it. Make sure to take pics. Team Subsonic Lows Get your garbage EMF products of my amp bitch Man....it makes a nice work bench
MatthewBigBossWilliams Posted July 12, 2014 Author Report Posted July 12, 2014 Amp. Run it and burn it. Make sure to take pics. I just now ran it and it read 13.5v steady then went to 12.9v steady. The amp does say 0.5 on it but as long as i dont run it at full power like for a long time i think it will be fine. I am going to be upgrading the amp to a Lanzar OPTI7001D and run that at 2ohms. since it is a 2013 ford focus, there are no H/O alts for the car yet, so I am stuck using the 120amp stock.
Miguels Posted July 12, 2014 Report Posted July 12, 2014 what sub did you get? my logshttp://www.stevemead...-my-new-set-up/my blow through loghttp://www.stevemead...future-updates/ 96 ss http://www.stevemeadedesigns.com/board/topic/164094-96-impala-ss-build/
MatthewBigBossWilliams Posted July 12, 2014 Author Report Posted July 12, 2014 what sub did you get? FI SP4 15 Dual 1ohm
Noel989 Posted July 12, 2014 Report Posted July 12, 2014 Just run it at 2ohms Build Log - http://www.stevemead...-cruiser-el-pt/
REH Posted July 12, 2014 Report Posted July 12, 2014 I use my bxi @ .5 daily, But that's because my options are 2 ohm/.5 ohm. Yours are 1.4/.35, I wouldn't trust wiring @ .35 on it but if you're brave enough.. It's yours. I'll say that there's a definite loss of sound quality I noticed when I took mine to .5, so I can only assume that going even lower than that it'll be more noticable.
MatthewBigBossWilliams Posted July 12, 2014 Author Report Posted July 12, 2014 It will go into protect before anything so I think keeping it at .5 will be alright until the replacement comes in
byers319 Posted July 12, 2014 Report Posted July 12, 2014 You miss the part where you are not at .5 you are actually at .35?
MatthewBigBossWilliams Posted July 12, 2014 Author Report Posted July 12, 2014 You miss the part where you are not at .5 you are actually at .35? How did I get that low and how do I just fix it?
Noel989 Posted July 12, 2014 Report Posted July 12, 2014 Just wire it to 2ohm (in your case 1.4) No single hifonics amp is capable of powering an sp4 Build Log - http://www.stevemead...-cruiser-el-pt/
Recommended Posts
Archived
This topic is now archived and is closed to further replies.