M6 terminal hardware enough?

[reedal]

I'm having a hard time locating the answer to my question. About to purchase a D4700, and it comes with the M6 terminal hardware, so do i need to purchase the 580 short post adapters as well if I'm going to have the SHCA 1/0 battery terminals on there? The image of the terminals look like its only a bolt that can fit through, just needing some clarification. I dont want to buy the posts and not need them or them not work with the terminal.

[evermaxx]

no.

if anything you made need longer bolts.

[reedal]

So no for the posts? Or no the m6 terminal bolts aren't enough to hold the shca terminals?

[tacomaguy1]

how many terminals per + and - are you planning on having

can get longer bolts easily from a hardware store

[tacomaguy1]

or are you asking if the m6 is big enough to hold it...as in width wise. Like the hole on the sky high lug is too big?

Just use a washer, it holds them just fine

Edited September 23, 2014 by tacomaguy1

[CNF Kevosinn]

for our terminals you need to get a longer bolt. I can provide the bolts you need with ours if you cant source them.

[reedal]

It's just going to be one positive and one negative terminal per bolt. I contacted SHCA about a month ago inquiring about a military discount and was instructed to send an email with my order request to receive the discount. But as long as just using bolts will hold the terminals to the battery without having to purchase battery posts as well, then thats good enough for me. I can buy some longer bolts and add washers that fit if needed. Any suggestions on the size/length? Thank you for the help.

[evermaxx]

for 1 pos and 1 neg youll be fine with the m6 ones.

[reedal]

Thank you