Dc Lvl 4s

[BASS14]

ya i know it would "well i would figure it would" .... thats why i also put faulty sub also.....

idk..... good luck...

yea idk....thanks bro!

[AI James]

check your wiring maybe one of the subs wiring has a short in it or something.

[BASS14]

check your wiring maybe one of the subs wiring has a short in it or something.

already checked em.....they checked out fine! that is y im stumped!

[Dale]

are you using same size and length wire to both subs? I had an issue like that, and one of my subs would move more than the other. The only thing I can think of is that one sub is getting more power than the other, so either the sub that is getting more power is getting too much or the other one is getting too little....so in any case there could be clipping

[BASS14]

are you using same size and length wire to both subs? I had an issue like that, and one of my subs would move more than the other. The only thing I can think of is that one sub is getting more power than the other, so either the sub that is getting more power is getting too much or the other one is getting too little....so in any case there could be clipping

They are running of my Rockford T1000.1bd @ 1ohm.....1600rms 800each....and yea they are the same wire its all rockford wireing as well!!i just dont get it....im stumped!

[WCA Rusty]

swap the woofer postions and see if the issue stays where it is, or if it moves with the woofer, that will tell a lot right there.

[BASS14]

thats wat ill be doin here in a bit!!

[BASS14]

i used a DMM and the sub that gets hot on one side read a steady 2.0 and the other side was jumpin from a 1.9-2.2......and the sub that doesnt get hot was reading a steady 1.1 on both sides!!