Jump to content
Second Skin Audio

Box Design


Socky

Recommended Posts

Can someone help me with a box design for my sub. Its a diamond audio d3 15, i currently have 1 whole sheet of mdf to work with. I listen to anything, but i love the low c&s stuff, this will be going in my room, therefore low tuning is always a plus.

Jeep Cherokee 4dr -4.75 in front, new rusty's 4.5 in rear leafs -micky thompson 35x14.50x15 -locker rear -Rusty's offroad Engine/transmission/transfer case/crossmember/gas tank skid plates -Warn front bumper with 8000lb winch -Custom rear bumper -Warrior product tube doors (summertime) -Optima redtop (starter) -26XK miles and still runs like a bat out of hell

Kenwood H/U

1/0 wire,

136 amp alt 200 ah batteries 12.7 daily

2 Apsm 1500 @ 2 ohm strapped on zv3 d1 with ns softparts

Mb quart 125.4 wired to 4 aura 6's

3.6 cube box tuned to 36 plays down to 23hz

Link to comment
Share on other sites

Then you'll want a T-Line for it, You'll need to post a link to the sub so they can see all the t/s parameters and amount of power you intend to use. Sorry i don't make or design t-line boxes but i'm sure someone will point you in the right direction.

01 Ford focus ZX3

Pioneer AVH-X491BHS

PPI PC 4800.2

Morel Maximo 6.5" x2

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 688 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...