Can I cut a port in half?

[FreekDesignz]

I have a box and I'm doing a flared slot port the inside specs are

14"wide

9"tall

14.75"long

So can I do 14x9x9 and split it into a T. Each side would be 5.75" long and 9" high. Would that effect the tuning? If so by how much?

Edited November 16, 2010 by thafreek

[FreekDesignz]

answer?

Edited November 16, 2010 by thafreek

[FreekDesignz]

TTTTT

[FreekDesignz]

ToTheTop

[matt3477]

Bump

[uhoh_45]

if you are talking about a box like this

you need to make sure you take the middle port in this case 7" and divide by 2 for the rear ports so it goes 3.5 into 7"

like this

not like this

hope this is what you asked if not i dont know

Edited November 16, 2010 by uhoh_45

[skittlesRgood]

i cant visualize what your trying to describe. are you trying to cut port length? are you putting a port in between the subs so they will be in their own chambers?

maybe you should make a pic. and when you list dimensions dont change the order, or if you do, list L W H: 3w x 5h - 5x3. makes it very confusing.

[FreekDesignz]

Like the 2ed pic. The port won't be divided in the middle only at the ends

[Torres]

yes. as long as the width is 7"

[FreekDesignz]

i cant visualize what your trying to describe. are you trying to cut port length? are you putting a port in between the subs so they will be in their own chambers?

maybe you should make a pic. and when you list dimensions dont change the order, or if you do, list L W H: 3w x 5h - 5x3. makes it very confusing.

I have a pic but my phone crashes every time I try to upload. And my home Internet is down.