Hold on. Someone correct me if im wrong but power is power. If you are making 2000 watts at 4 ohms or 2000 watts at 1 ohm wont you pull just about the same amount of power?
Yes and no. Not counting efficiency then it should take the same power. However, amps run more efficient the higher the ohm load.
Where this guy is getting confused is he is only considering the output of the 2 amplifiers.
3k at 4ohms is 110 volts (27.5 amps)
3k at 1ohms is 55 volts (55 amps)
yes, 1 ohm is more current, but this is amplifier output.
Since the voltage on the input side of the amp is constant (12v, 14v, 16v, etc....) then current is what varies. The more output your amp has, the more current it uses. To get an amp to increase it's output amperage (3k @1ohm), the input amperage goes up. To get an amp to increase it's output voltage (3k @4ohms), since the input voltage doesn't change, the input current goes up. Yes it will require less current since the amp is running more efficiently, but not much.
For example, a RF T600-4 is 71% at 4ohms and 68% at 2ohms. There would probably be a bigger loss than 3% efficiency IF the amp was 1 ohm stable, but still you are probably looking at about 10% efficiency.
So like I said earlier, if you don't have the power for 3K at 1ohm, you very likely don't have the power for 3k at 4ohms.
This was how my step-dad (a retired skilled trades electrician for GM) explained it to me. He's no electrical engineer but he certainly does know electronics very well.