uhoh_45

thats cool in a gay way

BNIB Brand new in box or box open but still new? if its now BNIB cut the tape lines the box and turn the box inside out and retape it so workers dont steal it (learnt that from the A-team) ha or get a bigger box and double box it haha

put some 6.5's in rear place of 6x9s

pros= amazing amps cons= your sons college fund

best get on that haha at least it isnt snowing yet i got 2" of snow here since i talked to ya last

updates

drill your own ha

i had each sub wired to .35 (2 subs wired to 1 amp) internally bridged down to 0.175 per amp

there solid amps and strappable i ran my xa3000d at 0.175 ohms on a 16 volt system and they never sweat but like everyone said your going to need 2 to get the subs your want moving haha edit got the wrong imp subs were duel .7s wired down to .35 each then connected to the amp bridged down to 0.175 ohm

if you are talking about a box like this you need to make sure you take the middle port in this case 7" and divide by 2 for the rear ports so it goes 3.5 into 7" like this not like this hope this is what you asked if not i dont know

get a powerbass xa 3000 or its bigger brother

i want pictures that is all i just dont know how your going to go bout this but either way best of luck and im here to help if needed

so you plan on building this in a trunk car? and yeah 20^2" on port is to much go with like dwite said (but i dont know what the 2500 series likes) but stay away from 11^2" port

oh this was in person or over msn i dont remember (talking to clay bout this was like 2 years ago) and my exploder i gave up on and got rid of it to much work and wasnt worth it the explorer was up and going but never 100% only had 2 of the 4 amps installed and never metered it with bandpass but it was louder then flat wall for sure (flat wall loudest 154 + change )

keep the sealed box's separate if your looking for numbers 4rth orders take lots trial and error the A-team had explained bunch bout his 4rth order ( 6 lvl 5 12s) that you do separate chambers so you can fine tune each sub individually say one chamber is 1.4 cubes where another could be 1.3 and so on i know with my box's i built them to 1.5 and found they liked smaller sealed box's so i ended up shrinking the box's to 1.35sh by adding bunch 2x4s on the inside of my box's to shrink them hope this helps

check out my build log it might benefit you - explorer - 4-15s - 4rth order bandpass

sounds solid just like my 4rth order spec wise give or take couple cubes ported and i was tuned higher 60 hz yet peaked in the lower hz's

i'm also looking for some LED rope in purple for buddys box

what if there 12 volt LED strips? and how would the leds break from the bass?

what you think your cool logan you think your better then everyone else or something huh cause you heard it before us well guess what it is rather old but still informative

you sure you got the rca's in the right holes ?

you need a bridging module or 16 bridge hope this link helps

problem with that N8 is that engine is huge and not electric i'm looking to power the trike i'm building

a-team runs DC subs yes and last i remember MnM (riprock) were still running 9918z's