Jump to content
Second Skin Audio

What size cubic foot box in YOUR blazer?


Recommended Posts

I'm in the process of planning out more ideas for a new system but will be keeping the same platform. (The Blazer) I'm looking to find out what size boxes you guys have got in the back and weather or not an 8-10 cu.ft box would be too larger for my liking. I'm just looking for input essentially. Pictures of said boxes would always be helpful as well.

2001 GMC Jimmy SLE 4X4 Floor Shift AutoHeadunit - Alpine CDA-117Front Door Speakers - Alpine SPS-600C MidsRear Door Speakers - NoneDash Speakers - Alpine SPS-600C TweetersSub Amp - Rockford Fosgate T4002Mids+Highs Amp - Rockford Fosgate P4004Subwoofer - P3D215 Fosgate Punch 15Sub Box - Rockford Fosgate designed "powerful" ported box Built by myself

i would rather run cheaper but sexier then expensive and fucking ugly.

Link to comment
Share on other sites

I also have a blazer. I need to build a box for two Dc 18 xl's. I want to keep my back seats, My plan is to gut the back, and build a wall. I hope to get a 12 cube box. With room to mount amps in the far back. I would like to take out the center console and put in 4-5 batteries and box them in. We will see how it works out.

Link to comment
Share on other sites

I to am looking at a few options on subs and most of the combinations i want are asking for around a 10 cubic foot box. I dont mind gutting the back of the car if thats what i have to do. Then again I do not want to lose my seats or all of my view out the back. Hopefully ill be able to find a way to keep the rear seats, as much rear view as possible, and the right amount of space.

2001 GMC Jimmy SLE 4X4 Floor Shift AutoHeadunit - Alpine CDA-117Front Door Speakers - Alpine SPS-600C MidsRear Door Speakers - NoneDash Speakers - Alpine SPS-600C TweetersSub Amp - Rockford Fosgate T4002Mids+Highs Amp - Rockford Fosgate P4004Subwoofer - P3D215 Fosgate Punch 15Sub Box - Rockford Fosgate designed "powerful" ported box Built by myself

i would rather run cheaper but sexier then expensive and fucking ugly.

Link to comment
Share on other sites

designed this box for an RE MX 18 to be ran inverted. :shrug:

perspec.jpg

for a blazer.

Edited by 412 CVX

Just say no to Ground Pounder Customs.

More box builds

some cars do over 170db with one sub, so clearly my two 12"s can do that in my car, with my knowledge too! look out bitches!

I'm with captain stupid.

Link to comment
Share on other sites

Do either of you happen to have pictures of the boxes in your blazers? Im looking to have it the lowest i can on the window line. I figured i would have to plan on cutting out the area the jack is in aswell as building it around the wheel wells for maximum space if i really want to keep it as low as possible.

2001 GMC Jimmy SLE 4X4 Floor Shift AutoHeadunit - Alpine CDA-117Front Door Speakers - Alpine SPS-600C MidsRear Door Speakers - NoneDash Speakers - Alpine SPS-600C TweetersSub Amp - Rockford Fosgate T4002Mids+Highs Amp - Rockford Fosgate P4004Subwoofer - P3D215 Fosgate Punch 15Sub Box - Rockford Fosgate designed "powerful" ported box Built by myself

i would rather run cheaper but sexier then expensive and fucking ugly.

Link to comment
Share on other sites

my brother has like 20+ cubes in his, but its a 4th order wall lol.

Jeep Cherokee 4dr -4.75 in front, new rusty's 4.5 in rear leafs -micky thompson 35x14.50x15 -locker rear -Rusty's offroad Engine/transmission/transfer case/crossmember/gas tank skid plates -Warn front bumper with 8000lb winch -Custom rear bumper -Warrior product tube doors (summertime) -Optima redtop (starter) -26XK miles and still runs like a bat out of hell

Kenwood H/U

1/0 wire,

136 amp alt 200 ah batteries 12.7 daily

2 Apsm 1500 @ 2 ohm strapped on zv3 d1 with ns softparts

Mb quart 125.4 wired to 4 aura 6's

3.6 cube box tuned to 36 plays down to 23hz

Link to comment
Share on other sites

Do either of you happen to have pictures of the boxes in your blazers? Im looking to have it the lowest i can on the window line. I figured i would have to plan on cutting out the area the jack is in aswell as building it around the wheel wells for maximum space if i really want to keep it as low as possible.

http://www.stevemeadedesigns.com/board/topic/98015-blazer-4-door-2-18s-fi-qs/

:drinks:

7w1lnOR.jpg

2004 Bagged Trailblazer

(4)18" Sundown Nsv3s
(4) Taramps HD10000s, Taramps DSP3000, Lanzar opti 250x2, AB 100x4
(2)DC power SP 270s, (14)XS Power d3100s, (1)d6500

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   1 Member, 0 Anonymous, 1707 Guests (See full list)

×
×
  • Create New...