REVOofRustler Posted August 8, 2012 Author Report Share Posted August 8, 2012 I'll see what I can get done with the wire i have. If I need more I'll probably just order some more knu stuff. I like to keep things the same haha. Thanks though! 2002 Dodge Dakota 4.7 club cab - Sold 2004 Audi S4 Avant - Fi and Crescendo - Stock Bose System - http://www.stevemeadedesigns.com/board/topic/147725-2002-dodge-dakota-end-of-the-road/?hl=%202002%20%20dakota 136.4 Sealed @ 29hz 137.0 Drivers window open @ 26hz Link to comment Share on other sites More sharing options...
REVOofRustler Posted August 10, 2012 Author Report Share Posted August 10, 2012 I got all my 0 gauge ran today! The only issue right now is that I'm still waiting on my fuse blocks to come in the mail, so I'm still running off a 4 gauge power wire... Took out the seats and center console This is the kind of mess that I didn't want anymore You have to take out all the trim panels just to get underneath the rear cargo area... New ground location. It's where one of the rear seat belts bolts to, and it's under the cargo area so it'll be nice and concealed 4 gauge vs 0 gauge From the battery... And down by the hood hinge From there to the door hinge Here's the grommet where I'll be running the wire into the cab Cut a hole in the grommet Then into the cab! It comes straight in by the kick panel and then it go right under the door sill. Ran all the wires into the cargo spot behind the amp. This is normally where the jack and stuff would go, so I need to figure somethin out for that... I cut a hole through the cargo area to run all the wires out to the amp Lookin a bit cleaner... It's a miracle I got all the trim pieces back on right... Stupid 4 gauge... Vacuumed it up a bit And here's how it's gonna sit until I get the fuse blocks in and can actually use the 0 gauge power wire. That's all for now! 2002 Dodge Dakota 4.7 club cab - Sold 2004 Audi S4 Avant - Fi and Crescendo - Stock Bose System - http://www.stevemeadedesigns.com/board/topic/147725-2002-dodge-dakota-end-of-the-road/?hl=%202002%20%20dakota 136.4 Sealed @ 29hz 137.0 Drivers window open @ 26hz Link to comment Share on other sites More sharing options...
revoracing247 Posted August 10, 2012 Report Share Posted August 10, 2012 tuned in. sweet stuff man! im looking at doing a set up kind of like your's but for my ranger. I think you have a bit of truck stuck in your mud bro ~Ford Ranger, ext cabKenwood DDX4701/0ga stinger wiring for big 31/0ga ofc flextech wiring 3 kinetik 800's AQ2200 @1ohm Sundown Audio X15 in a 27Hz tuned ported box LE BUILD LOG!!! Link to comment Share on other sites More sharing options...
KiKaZz74 Posted August 10, 2012 Report Share Posted August 10, 2012 I kind hate u now. u got ur damned front seats out... I broke a bolt off in the chassis and didnt realize its a one piece seat... Wouldve made getting the box in so much easier. But very nice job so far bro. Im liking how u ran the wire still tuned My SPL to SQ Build Log Vehicle:1997 Dodge Dakota Ext Cab 4x4 2009 Dodge Journey SXT5.2L V8 Magnum 3.5L V6 Stock AltEquipment: Headunit- Alpine CDE-147BT Mids/Highs Amp- JL Audio G6600 Class AB 6 Channel Sub Amp- Hifonics BRZ1700.1D @ 2 Ohms Taramps DSP3000.1D Sub- Hertz Hi Energy 12" HX300D SounDrive SDA3 12 Tweeters- Rockford Fosgate Power Series Silk Domes Hertz Hi-Energy Mids- Dayton Audio Reference 4" Full Range Drivers Midbass- Silver Flute 6.5" Hertz Hi-Energy 6.5" Processor- MiniDSP 2x4 RCA- 6 channels of SounDrive HF series Wire- EB Flex 2/0 -Member of Team SounDrive Link to comment Share on other sites More sharing options...
REVOofRustler Posted August 10, 2012 Author Report Share Posted August 10, 2012 tuned in. sweet stuff man! im looking at doing a set up kind of like your's but for my ranger. Thank you! Haha I kind hate u now. u got ur damned front seats out... I broke a bolt off in the chassis and didnt realize its a one piece seat... Wouldve made getting the box in so much easier. But very nice job so far bro. Im liking how u ran the wire still tuned That sucks! I've gotten pretty good at takin my seats out and puttin em back in haha. And I'm sure you're 18 will get louder than my 12! 2002 Dodge Dakota 4.7 club cab - Sold 2004 Audi S4 Avant - Fi and Crescendo - Stock Bose System - http://www.stevemeadedesigns.com/board/topic/147725-2002-dodge-dakota-end-of-the-road/?hl=%202002%20%20dakota 136.4 Sealed @ 29hz 137.0 Drivers window open @ 26hz Link to comment Share on other sites More sharing options...
REVOofRustler Posted August 12, 2012 Author Report Share Posted August 12, 2012 Soo, I'm still waiting on my fuse blocks (Monday is the last day usps said they would arrive), so still no 0 gauge power wire haha. However, I did gain quite a few rattles after pulling out all my panels and putting them back in. Deadener is starting to sound more and more like a good idea every day... 2002 Dodge Dakota 4.7 club cab - Sold 2004 Audi S4 Avant - Fi and Crescendo - Stock Bose System - http://www.stevemeadedesigns.com/board/topic/147725-2002-dodge-dakota-end-of-the-road/?hl=%202002%20%20dakota 136.4 Sealed @ 29hz 137.0 Drivers window open @ 26hz Link to comment Share on other sites More sharing options...
KiKaZz74 Posted August 12, 2012 Report Share Posted August 12, 2012 See I shouldve done deadener before the build. can't happen now but cmon get that 0ga working! I wanna see some vids btw My SPL to SQ Build Log Vehicle:1997 Dodge Dakota Ext Cab 4x4 2009 Dodge Journey SXT5.2L V8 Magnum 3.5L V6 Stock AltEquipment: Headunit- Alpine CDE-147BT Mids/Highs Amp- JL Audio G6600 Class AB 6 Channel Sub Amp- Hifonics BRZ1700.1D @ 2 Ohms Taramps DSP3000.1D Sub- Hertz Hi Energy 12" HX300D SounDrive SDA3 12 Tweeters- Rockford Fosgate Power Series Silk Domes Hertz Hi-Energy Mids- Dayton Audio Reference 4" Full Range Drivers Midbass- Silver Flute 6.5" Hertz Hi-Energy 6.5" Processor- MiniDSP 2x4 RCA- 6 channels of SounDrive HF series Wire- EB Flex 2/0 -Member of Team SounDrive Link to comment Share on other sites More sharing options...
REVOofRustler Posted August 12, 2012 Author Report Share Posted August 12, 2012 See I shouldve done deadener before the build. can't happen now but cmon get that 0ga working! I wanna see some vids btw Haha yeah. I can pull my truck apart pretty quickly by now if I ever wanna do deadener. I'm gonna try to get a new vid up tonight! 2002 Dodge Dakota 4.7 club cab - Sold 2004 Audi S4 Avant - Fi and Crescendo - Stock Bose System - http://www.stevemeadedesigns.com/board/topic/147725-2002-dodge-dakota-end-of-the-road/?hl=%202002%20%20dakota 136.4 Sealed @ 29hz 137.0 Drivers window open @ 26hz Link to comment Share on other sites More sharing options...
REVOofRustler Posted August 12, 2012 Author Report Share Posted August 12, 2012 Here's a little video for ya. My truck flexes a little more than the camera shows (which really isn't that much)... but hopefully this will hold you over til I get it all complete! 2002 Dodge Dakota 4.7 club cab - Sold 2004 Audi S4 Avant - Fi and Crescendo - Stock Bose System - http://www.stevemeadedesigns.com/board/topic/147725-2002-dodge-dakota-end-of-the-road/?hl=%202002%20%20dakota 136.4 Sealed @ 29hz 137.0 Drivers window open @ 26hz Link to comment Share on other sites More sharing options...
REVOofRustler Posted August 14, 2012 Author Report Share Posted August 14, 2012 Fuse blocks!!!! This one is going right by my amp, it's mounted inside the amp rack With the cover on The amp rack does a decent job concealing wires... I also painted it black with Plasti-dip Nice mess of wires... It all looks clean though! Old vs. new Here's how it will be with the big 3 fuse block. I'm a few feet short on wire to get my big three done, so that will be the next step All hooked up For some reason while I was installing my 4 gauge, I thought it would be a good idea to run it through my dash. I had to take out my deck so I could get my hand back there and feed it out bit by bit... And back to normal! So that's what I got done today! I've decided that I'm going to start saving up now for the Fi, instead of the battery (which will be an XS Power d2700). This way, I can get the sub and run it at 4 ohms to break it in. Then once I have the money for the battery I'll be able to wire it to 1 ohm and run it full tilt with no concerns! 2002 Dodge Dakota 4.7 club cab - Sold 2004 Audi S4 Avant - Fi and Crescendo - Stock Bose System - http://www.stevemeadedesigns.com/board/topic/147725-2002-dodge-dakota-end-of-the-road/?hl=%202002%20%20dakota 136.4 Sealed @ 29hz 137.0 Drivers window open @ 26hz Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.