teardrop Posted December 18, 2012 Report Share Posted December 18, 2012 im trying to figure out how to do a T shaped port instead of say a L shaped port im wanting a 5 in wide port so when it T's off will the port stay 5 in on both sides or goes to 2.5 in on both sides? Link to comment Share on other sites More sharing options...
will77530 Posted December 18, 2012 Report Share Posted December 18, 2012 goes to 2.5 Link to comment Share on other sites More sharing options...
teardrop Posted December 18, 2012 Author Report Share Posted December 18, 2012 thank you sir Link to comment Share on other sites More sharing options...
teardrop Posted December 18, 2012 Author Report Share Posted December 18, 2012 what about the length does it get plit in half between the to halfs or stays the same for both Link to comment Share on other sites More sharing options...
Joe X Posted December 18, 2012 Report Share Posted December 18, 2012 And this is how the port length is measured: L1 + L2 is what Torres port length shows. Link to comment Share on other sites More sharing options...
teardrop Posted December 18, 2012 Author Report Share Posted December 18, 2012 ok thanks Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.