Zach Martino Posted April 5, 2013 Report Posted April 5, 2013 so i have a crescendo bc2000 and a zv3 18 , today the first day of this set up and i need some advice on setting gains , the amp just goes into over protecdtion i have the bass boost off subsonic little less than a 1/3 , my head unit is all flat and is 2.2v preout , would a line driver help? my volt meter shows almost 15 v
SLAYER1805 Posted April 5, 2013 Report Posted April 5, 2013 Where's the gain at now? What are you wired to? Sounds strange for it to be going into protect like that
rockFord_Expedition Posted April 5, 2013 Report Posted April 5, 2013 Where do you get the 15v reading? At the amp? And are you using a DMM? Where is your gain set to now? Old School/New School RF Build March 2015 SOTM Winner How to crimp large wire
SnowDrifter Posted April 5, 2013 Report Posted April 5, 2013 What ohm load are you at? ~~~~~~~~SAY NO TO PHOTOBUCKET~~~~~~~~ Snow's DD-1 tracks here: https://www.stevemeadedesigns.com/board/topic/167433-snows-dd-1-tracks/ My take on OFC vs CCA: https://www.stevemeadedesigns.com/board/topic/110381-things-that-piss-you-off-in-the-car-audio-world/?do=findComment&comment=2461444
Zach Martino Posted April 5, 2013 Author Report Posted April 5, 2013 i have it wired at 1 ohm , i get the 15 v from a volt gauge on my dash , itll sit between 14.4 and 15 , but when its under a load it drops to maybe 12 and its lowest , i cant find anyone with a dd1 or oscope ,
Zach Martino Posted April 5, 2013 Author Report Posted April 5, 2013 and honestly the woofer just doesn't even sound good , my little bass knob shows clipping aswell
soundstream15 Posted April 5, 2013 Report Posted April 5, 2013 did you look on the smd tool maps http://www.stevemeadedesigns.com/board/topic/137758-smd-audio-tools-map/
Zach Martino Posted April 5, 2013 Author Report Posted April 5, 2013 i have not i will have to scope it out
Recommended Posts
Archived
This topic is now archived and is closed to further replies.