donpablo Posted July 31, 2014 Report Share Posted July 31, 2014 Im not sure if this is even an amp issue or what but my bass is not kicking in till i hit high vol on my deck So i turn up to max vol or near it and my bass is on but as soon as i turn it down it cuts off 2015 F-150 Platnuim Link to comment Share on other sites More sharing options...
SIDE SHOW Posted July 31, 2014 Report Share Posted July 31, 2014 need more info mate, what gear do you have, what electrical does your car have, what are the amp and deck setting set to, are you using a bass knob ect Link to comment Share on other sites More sharing options...
Weigel21 Posted July 31, 2014 Report Share Posted July 31, 2014 As stated, insufficient info. Could be the sub setup is wired for a high impedance thus the amplifier produces little power, could be improper gain setting, poor ground for the amp, EQ set to cut lows, bad RCA cables, etc etc etc. Link to comment Share on other sites More sharing options...
donpablo Posted July 31, 2014 Author Report Share Posted July 31, 2014 Stock battery, stock hu, eq is flat, every thing is set with the dd1, 160 amp alt, dc 3.5k, 2 dc lvl 4 12s, 1 xs 3100d, lci 2 line output 2015 F-150 Platnuim Link to comment Share on other sites More sharing options...
donpablo Posted July 31, 2014 Author Report Share Posted July 31, 2014 No bass knob using pac 2015 F-150 Platnuim Link to comment Share on other sites More sharing options...
donpablo Posted July 31, 2014 Author Report Share Posted July 31, 2014 I should also add some times it works a low vol but its rare also the is always on when it does this 2015 F-150 Platnuim Link to comment Share on other sites More sharing options...
SIDE SHOW Posted July 31, 2014 Report Share Posted July 31, 2014 your stock deck has rca pre-outs? no bass knobs using PAC? whats pac mean. whats your gain, bass boost, eq, lpf hpf and subsonic filter set too on the amp? Link to comment Share on other sites More sharing options...
SIDE SHOW Posted July 31, 2014 Report Share Posted July 31, 2014 lci 2 line out.... <-- test that Link to comment Share on other sites More sharing options...
Noel989 Posted July 31, 2014 Report Share Posted July 31, 2014 What's the impedance of your subs? What stock hu are you using, what car? Build Log - http://www.stevemead...-cruiser-el-pt/ Link to comment Share on other sites More sharing options...
islandpride684 Posted July 31, 2014 Report Share Posted July 31, 2014 Adjust your LC2i..... Build Log http://www.stevemeadedesigns.com/board/topic/186921-blk9te-07-yukon-slo-mo-build/page-3?hl=%2Bblk9te#entry2881410 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.