Kyblack76 Posted October 18, 2014 Report Share Posted October 18, 2014 When you say, "it doesnt power my sub at all" Does that mean, they do not even MOVE, like ZERO output? Or, it moves the drivers, just really weak? SMD SUPER SELLER The Burban Build Blazer Build sold Acura trunk build sold Link to comment Share on other sites More sharing options...
Kyblack76 Posted October 18, 2014 Report Share Posted October 18, 2014 When you say, "it doesnt power my sub at all" Does that mean, they do not even MOVE, like ZERO output? Or, it moves the drivers, just really weak? SMD SUPER SELLER The Burban Build Blazer Build sold Acura trunk build sold Link to comment Share on other sites More sharing options...
Zero_Tolerance_ Posted October 18, 2014 Author Report Share Posted October 18, 2014 When you say, "it doesnt power my sub at all" Does that mean, they do not even MOVE, like ZERO output? Or, it moves the drivers, just really weak? I mean they don't move them at all... Link to comment Share on other sites More sharing options...
P4killer_ Posted October 18, 2014 Report Share Posted October 18, 2014 Make sure if you have master slave switch, its set to master. Also make sure the rcas arent plugged into the output side instead of the inputs. Setup: 2010 Hyundai Elantra Factory Unit via 4 chan NVX LOC Excessive Amperage "H/O" Alt Xs D3400/ Xs XP3000 Big 3. 2 Runs of +, 2 Runs of - DD M3b and 2 12" AQ HDC4s Link to comment Share on other sites More sharing options...
Zero_Tolerance_ Posted October 18, 2014 Author Report Share Posted October 18, 2014 Make sure if you have master slave switch, its set to master. Also make sure the rcas arent plugged into the output side instead of the inputs. The amp only has one set of rcas, so... Link to comment Share on other sites More sharing options...
Kyblack76 Posted October 18, 2014 Report Share Posted October 18, 2014 Check AC voltage out SMD SUPER SELLER The Burban Build Blazer Build sold Acura trunk build sold Link to comment Share on other sites More sharing options...
OrionStang Posted October 18, 2014 Report Share Posted October 18, 2014 OP, did you test it yet? SMD Super Seller My Feedback Thread Link to comment Share on other sites More sharing options...
Zero_Tolerance_ Posted October 18, 2014 Author Report Share Posted October 18, 2014 Not yet.. Hopefully I can get to it in the next hour here. Link to comment Share on other sites More sharing options...
Zero_Tolerance_ Posted October 19, 2014 Author Report Share Posted October 19, 2014 So while listening to a 40hz test tone, I get no voltage at the speaker outputs on the amp. I tested the rcas as well and they have no voltage either. While testing I noticed it started to smell like something electrical was burning up. Everything is brand new. CT Sounds 1400.1 powering a FI SSD 12. All SHCA OFC wiring. Now what should I do? Link to comment Share on other sites More sharing options...
OrionStang Posted October 19, 2014 Report Share Posted October 19, 2014 What headunit do you run. Some aftermarket head units have a subwoofer on/off setting. SMD Super Seller My Feedback Thread Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.