Jump to content
Fi Car Audio

**finally Installed** 18" Fi Btl's


Tkitt21

Recommended Posts

Posted

thats wat im wantin both 18's n that box so itd b 6.5 cubes per sub but im not sure how big that box would b to c if itll fit in my car

~REFS~

-CA.com-Gianotti(2 18" FI BTL D1) Slowd N Throwd(Wiring),Ebrunn(PC monitor),Rab(HK4000D)

-SMD.com-Nismofreak(Radar),BigP(Phone Headset),anonymous(Xbox360 Headset)

Posted

Won't fit

Both subs take a half a cube displacement and the port most likly will take a full cube

So minus 1.5 cubes in displaments

Plus its accord they don't got that much space you could allways wall it :)

Have you ever had your woofers blown?

Posted

thats wat i was gonna do was wall it but its a 1990 honda accord 4dr ex POS..it has 275k miles on it front seal leaks bad power steering leaks frictions plates are gone in the tranny and need a rebuild cv joints r bad. smokes too, and laitly its been running really hot.. So all i gotta do is put put it around fo 6months until i can get a loan and im gonna try to get my uncles truck from him..and i kbb'd my car at $570.00 so im not gonna wall it anymore

so just tell him to do a box for 1 ported?

btw my uncles truck is a 2005 chevy hd 2500 4door diesil rhino lining tuneo cover a bully dog chip givin it an extra 125 extra horse. an he has a lot more done to it..its a fully loaded truck lol

~REFS~

-CA.com-Gianotti(2 18" FI BTL D1) Slowd N Throwd(Wiring),Ebrunn(PC monitor),Rab(HK4000D)

-SMD.com-Nismofreak(Radar),BigP(Phone Headset),anonymous(Xbox360 Headset)

Posted

good luck fitting 13 cubes after displacement in the trunk

itd be going in the back seat.. I build a ported box for 1 but it was WAY messed up and i just set it in the back seat of my car..

~REFS~

-CA.com-Gianotti(2 18" FI BTL D1) Slowd N Throwd(Wiring),Ebrunn(PC monitor),Rab(HK4000D)

-SMD.com-Nismofreak(Radar),BigP(Phone Headset),anonymous(Xbox360 Headset)

Posted

thats wat i was gonna do was wall it but its a 1990 honda accord 4dr ex POS..it has 275k miles on it front seal leaks bad power steering leaks frictions plates are gone in the tranny and need a rebuild cv joints r bad. smokes too, and laitly its been running really hot.. So all i gotta do is put put it around fo 6months until i can get a loan and im gonna try to get my uncles truck from him..and i kbb'd my car at $570.00 so im not gonna wall it anymore

so just tell him to do a box for 1 ported?

btw my uncles truck is a 2005 chevy hd 2500 4door diesil rhino lining tuneo cover a bully dog chip givin it an extra 125 extra horse. an he has a lot more done to it..its a fully loaded truck lol

Ummmm if your car is junk why not get a single cheap 12 run it in the "smoker" and then get the loan and the truck and wall it? :unsure::pardon:

edit: and keep the 18s for your truck just wait a lil bit?

Vehicle: 1997 S10 Blazer 4dr 4X4

Exterior: Rear End Bagged, Black Grill, Lifted 2"

Amplifiers: Rockford Fosgate T8004 & T10001bd

Batteries: 2 Stinger SPV35, Kinetik HC2400

Electrical: Big 3, DC Power 290amp Alternator w/ MLA at 15.5v

Enclosure: 4.2 ft³ @ 33Hz 84sq.in. of port (20sq.in. per cube)

Headunit: Eclipse CD3200 w/ 80G iPod

Mids/Highs: Rockford T152s (a-pillars), Rockford T162s (doors)

Subwoofers: 1 15" Fi BL Fully Loaded

Wire: All 1/0g Kicker Hyperflex

My YouTube Videos

My Fiberglass A-Pillar Build

My "Seamless" Looking Box Build

My DD1508 T-Line Bandpass Build "Seamless" w/ Acrylic Windows (for '05 TrailBlazer)

My Stealth 8" Fiberglass Build (for '05 TrailBlazer)

My Build For A Friend's '08 Cobalt 15" BL Sealed Off From The Trunk

My feedback/references...

Posted

Self Destruct in 3...2...1 =@

lbb-2.png

2007 Chevy HHR LT

UNDER CONSTRUCTION

1st Place Loud N Low 2010 MWSPL Finals

3rd Place Xtreme 3 2010 MWSPL Finals

Posted

Self Destruct in 3...2...1 =@

ya lol im just waitin for it to go lol

I guess ill just run 1 of them off the hk4000d

~REFS~

-CA.com-Gianotti(2 18" FI BTL D1) Slowd N Throwd(Wiring),Ebrunn(PC monitor),Rab(HK4000D)

-SMD.com-Nismofreak(Radar),BigP(Phone Headset),anonymous(Xbox360 Headset)

Posted

alright i told him to do a ported 7cube box tuned to 35hz for a 18" fi fully loaded btl D1 ohm ran off a hk4000d and do internal bracing

~REFS~

-CA.com-Gianotti(2 18" FI BTL D1) Slowd N Throwd(Wiring),Ebrunn(PC monitor),Rab(HK4000D)

-SMD.com-Nismofreak(Radar),BigP(Phone Headset),anonymous(Xbox360 Headset)

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 1065 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...