dc lvl4 xl 15 question

[shainemcconnell]

curious..what is the Height and width of you port or port surface aera?

Edited July 6, 2009 by shainemcconnell

[LordArcane]

19.5"h x 4"w x 12"d slot port shouldn't have any port noise

[shainemcconnell]

nope that should be good..

but the routed edges will still be nice, we route all our port edges

Edited July 6, 2009 by shainemcconnell

[LordArcane]

all port edges will be 45's with a V peive in center of port between each chamber to help push the air out the port instead of chamber to chamber. and using 1" dolle and 45's on all corners for bracing might change box later when i learn more about making the but for now this seems good to me just need to save few months checks to get some bad ass dc's and give my type arrr's to my girl

[mbdblue]

got a single XL 15 runnin on 2600 watts in a little smaller than 3 cubes.....youll be fine....

[shainemcconnell]

all port edges will be 45's with a V peive in center of port between each chamber to help push the air out the port instead of chamber to chamber. and using 1" dolle and 45's on all corners for bracing might change box later when i learn more about making the but for now this seems good to me just need to save few months checks to get some bad ass dc's and give my type arrr's to my girl

Yup..ok ignore my routed edges..sounds like you got it covered weill enough;)

[LordArcane]

just to give everyone an idea this is what i got designed so far with the above specs

[Noobtastic14]

Lookin good to me!!!

-Drew

[shainemcconnell]

yup looks good

[wL<3bass]

I like all-thread better than dial rod...its stronger, cheaper, and less work.