Straping Amps w/ Maxxsonics Maxxlink

[SubSonic]

ok so, im not exactly sure on how to strap amps, iv seen a few ways, but when you have 2 amps, you have the RCAs from the HU to the first amp, then what do u sue to STRAP the other amp? iv seen single RCA from the Input from the first AMP to the Input of the second amp? iv also seen this

http://www.maxxsonics.com/corporate/news_0...f_MAXXLINK.html

is there anything cheaper?? and how exactly do you do this...

ALSO, just asking, I myself plan to run 4 15's DC lvl 4, or 15's FI BLs, and my buddy is gonna run ten 12" woofers at 200rms, in YOU OPINION, what system do u thin will slam harder, be louder, reach higher DB's, i mean, ill be running more power, but hes gonna have more cone area, so LMK WHAT YOU THINK, THANKS

[1030tooled]

To use the maxxsonic link, I believe only mono amps can only be used. Not sure if a certain class of amp is required. I too would be interested in more info if someone knows more.

[basshead4life]

To use the maxxsonic link, I believe only mono amps can only be used. Not sure if a certain class of amp is required. I too would be interested in more info if someone knows more.

same here

[newls1]

See, I dont want to strap 2 amps, but rather connect 2 amps to this. I do want to run the maxxlink so I have control over them using 1 piece of hardware, and 1 bass knob. I'm sure something like that is possible with this piece, I just have to read more into it.

[superduper]

post pictures when you figure this out..because im trying to do the same..with 2 bxi2006d..

[newls1]

maybe this will help, look at post number 13 ( http://www.stevemeadedesigns.com/board/ind...?showtopic=7728 )

[SubSonic]

Yea, but what about that single wire you use?? from input to input, on the amps..

And u can only strap Mono Amps right??

i have 4 Diamond 600.1 Amps, and id strap 2 and 2, to get 1200 RMS on each set, so lmk thanks

[BulletInjection]

Go onto the maxxsonics section on the forum, those guys come on and answer questions all the time