Jump to content
Sonic Electronix

Recommended Posts

Posted

so i'm getting my first system together. i have an aq1200d idk what subs i'm going get yet though.

any way what gauge wire will i need to do my big three

what gauge wire should i run to my amp subs etc

1/0 guage for power and ground

then 8 guage from amp to subs

Vehicle: 2017 Chevrolet Silverado High Country

Electrical: 320A Singer Alt, (2) Limitless Lithium 15ah, Full Throttle FT680-48

Speakers: Stevens Audio SA 6 (ACTIVE), Audio Designs 3”

Subwoofer: (4) B2 Audio XM 8’s

Amplifiers: (2) B2 Audio Rage 2500.1, (1) B2 Audio Rage 1200.6

Processors: NavTv M650 (integration), Helix DSP Pro MK2

 

Silverado Build Log

 

Posted

4 gauge will work fine for your application. 10 gauge from amp to subs

2004 Volkswagen GLI

1 10" Skar VVX

^^^ Looking for an amp to run it, Pm me if you have one ^^^

Posted

Quality 4gauge will sufficed.

But 1/0 doesn't cost to much more, and I'd rather do it right the first time, then go back and do it again.

Also, speaker wire depends on your impedance. 4ohm doesn't take as big of wire as 1ohm, to flow the same power.

Posted

Give me that 1200 and it'll get hooked up proper.

sorry man but you can't have it. you could help if you wanted to though but i think it would be quite the drive

thanks i was just wondering while i wait to decide what subs i might as well buy some wire

look at my super internets it beast!

http://speedtest.net/result/906958776.png

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 532 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...