EVAlonSo

The higher the order, the sharper the roll off

Just did one at work. very easy job. You can find a wiring diagram for it in one of the stickies at the top of the security section.

If its older and isnt a cable lock, you can disconnect the cylinder from the lock completely and just use actuators. only problem is... if battery dies you are SOL

Before you buy see if you can get the seller to flash your specific firmware or you will be SOL with a box that doesn't work with your vehicle. (unless default firmware is what you need) offer 5$ more for their time

id say 242db with that box

You can cut the wire on the antenna harness that controls the LED, and put it on a toggle or something

More shots in the morning

next time use a potentiometer

try a auxiliary cable to RCA and plug it into your phone and amplifier. play something for your phone as a source and see if it bumps. if it does you know the issue is behind the amplifier, and continue your troubleshoot.

Go out of their way to start shit with you? i hate people like that. /end of tonights rage.

Do both and go bandpass

Tested a DD-1 next to my scope. DD-1 = on point

door locks prevent the door handle from working. if you remove the door handle then.. well..

This. don't change programming yourself. you had it installed professionally and have a lifetime warranty. have them check for you whether tach is hooked up and not voltage sense or virtual tach. make them honor it. If tach is hooked up the threshold needs to be changed. Know that it is the holidays now and it is the busiest time of the year for them. call ahead and schedule an appointment and make sure the most knowledgeable installer at the shop can look at it for you. its really not a common problem, especially with DEI products, for vehicles to not start like that. i always run tach in all of my installs and its rare that a vehicle doesn't start consistently. when tach is learned the brain knows when the engine has started. if it doesn't start up the unit would hold the starter a little longer depending on the tach threshold as well. What t-money is explaining to you is to change the unit to read tach. the only problem with that is it wont work the first time because tach would have to be learned. if you do what he says it wont remote start anymore, though it is what needs to be done (after tach is connected). your best option for now would be to change it to virtual tach or voltage sense (whichever it is not on) and test. before you do all this though, take it to the installers. EDIT: he said 3 chirps, thats crank time

ipods and iphones used through USB are interfaced. the radio reads it off the unit sort of like a CD unlike aux where it replicates the sound. itunes claims their songs that you download are "lossless" and are CD quality.