ghostismyname

This is what i did, have to make sure you seal it up nice around the threaded rods hole. I used a 3/4" threaded rod, probably excessive but it worked great!

i personally try and stay away from any red light, blinking or non blinking, but thats just cuz im real paranoid i guess, but you cant go wrong if you pick a song with a variety of high and low notes in it and just tune it so its just below where it starts to blink occasionally.

Well IMO, those people think they know what they are talking about and don't. lol this also, and if you interested this weekend ill be getting my dd-1 and ill test out and see if my clip light on either of the remote gain nobs for my 2200's is accurate

super excited to get my dd-1, could you possibly sign it for me order #100002443

i dont know but this guy does, http://www.caraudio.com/forums/subwoofer-speaker-reviews/511391-american-bass-xd-8-review.html

i dont know if this helps, but im building a wall in my explorer. A 4th order for 2 18's. But im keeping my back seats, only way is i took the backrests off the back seats and the box will be the back rest.

Inverted is mostly for looks, but also saves on woofer displacement in ur box, since the majority of the woofer is not in the box

Thank you that's what I was looking for, probably won't be trying it for awhile for electrical reasons, or may just get 2 more 2200's to stay safe. Thank you all for your help.

yea basically im trying to figure out if i can wire my dual 1ohm subs to a one ohm load across the strapped amps(.5 each amp) Because when i wire the subs in parallel i can get either 1 ohm or 4 ohm load, i origanily had them wired to one ohm on a single 2200, and when i got my 2nd 2200 i strapped them togather and then just hooked them up same way. So right now each amp would be seeing 1 ohm right? yea i might in the end go with bigger amps, i just dont want to have to get rid of my 2200's lol i may just get another pair and run them strapped and have a strapped pair for each woofer.

But my subs are dual 1ohm, how can i strap amps to 1 ohm?

Ok so currently im running 2 aq 2200d's strapped, subs are wired to 1ohm and with that across a pair of strapped amps it means the full load is 2ohms at around 4400 watts correct? Well i want to know if anyone has wired their strapped amps to 1ohm (so .5 ohm each amp basically) if so how can you do this and would i be able to? I could wire each amp to a sub at .5 ohm, but if im correct running them strapped saves on my current and will help with keeping subs cooler and also i like keeping only one bass nob. Heres my setup, 2 aq 2200d's strapped, and 2 aq hdc4 18's.

Remove old regular 3 and measure out lengths of new 1/0 wire and add a few extra inches, makes it easier to work with.

Lol i skipped a few steps....and it surprised the hell out of me, used to it now tho.

Lol'd, well learning is half the fun sometimes.

I always thought a good general rule was "apply as needed" Try and coat the areas where the most flex will occur, thoroughly and minor areas a little less. You can always buy more later if you dont like the results.