Phawstir

I ordered a replacement harness for my DD-1 Thursday night. There was no info pertaining to shipping time to Canada. I tried calling, leaving a voicemail, and emailing D'Amore Engineering, all with no response. How long can I expect shipping and delivery to take for my replacement harness to make it to Canada (T5R ***)?

4699

CLEAN AS. looks great

Edit: I posted too late. Here's to hoping next week!

Any more reviews on these earbuds? I want to get a pair to replace some tired-ass iPhone earbuds but am now unsure after reading some of these comments

HOLY TOLEDO. This is sometin' else

I ran into a previously unrecognized woofer depth problem so here is another design. I think I finally have what I want. Please check it out and give me some feedback!

Unreal. Can't wait to see more!

annnnnyyyybooooddddyyyy?

How's this lookin...

I am still tinkering with numbers...but I have a question If I am going with design 1. (see first/original post) in regards to woofer placement, the ass end of my woofer (Alpine SWR-1541) will be facing the internal port wall. I am running into a slight issue with the mounting depth of the woofer and the internal port wall. My woofer is vented(?) on the ass end/magnet (pole venting?). How much room is required between the vented magnet of the woofer and the internal port wall, I have heard around 1 inch, but would like other input Edit: Here is the design question from my original post... I would like to pose the question again, which design is best, considering the length my slot port runs internally along the back wall. Ideally, I would like to go with design 3, as it would make life easier for me calculating this enclosure, save me a bit of cargo space, as well as I like this design most aesthetically. Will I experience significant losses in going with design 3 instead of design 1?

unless I'm wrong, you forgot to change the port height AB18VFL. Thanks for your input, I'm trying to balance quite a bit and with this being my first ported build i want to make sure I'm taking steps in the right direction. I listen to pretty much everything. For sure a good chunk of dubstep and rap/hip hop, but i still would like some musical capability for other genres, though they get a slight bit less playing time in my Jeep

No I don't. Ideally, I'd like this box to slam some lows, but still be musical for rock, metal, and other genres. Anything is going to be better than my 42hz tuned prefab in use at the moment. Thanks for the advice 412 you're really helping me out. I'll go see what numbers I can throw together. Any other advice would be much appreciated

How is this lookin' then? Edit: Also, my woofer mounting depth is a sliver under 9 inches. if the ass end of the woofer is pointing towards the port wall (along the internal back side of the box), there will only be just over an inch of gap between the magnet and port wall. Is this acceptable?

Thanks 412, back to your statement on shooting for 3.5 cubes net...I realize that I have low power, but that seems like a loooooot of volume. Manufacturer specs are ported box volume: 1.5-3.0 cubic feet, with an optimum volume of 2.25 cubes. I am unsure about this, as compared to your knowledge of box design and building. Edit: poor choice of wording