Jump to content

1/0 power cable


Recommended Posts

Posted

this is what I'm running.

2-aq2200ds strapped @1.4 ohms.

1-aq90x4.

320 amp alt.

big 3 in check.

2-deka intimidator G31 batteries out back.

one optima yellow top up front.

and now for my question.

how many runs of 1/0 should i have running back to my (small) battery bank?

i have one run for both the pos. and neg.

will this due?

or should i have @least one more run for both +&- ??

before you see the light, you must die.....

Posted

You can never have too much wire! But I would do at least 2 runs

2 Fi BTL N2 18s Fully LoadedSundown Audio NS-1Kenwood 845 HU Clarion EQ4 Juicebox 3100sKnu Wire"Big 3"Mechman 270a156.3dBTeam GG.

Posted

i would do 2 runs of 1/0 to be on the safe side, but you can never have to many as stated above. If i remember right someone had like 17 runs of 1/0 in the honda.

Jeep Cherokee 4dr -4.75 in front, new rusty's 4.5 in rear leafs -micky thompson 35x14.50x15 -locker rear -Rusty's offroad Engine/transmission/transfer case/crossmember/gas tank skid plates -Warn front bumper with 8000lb winch -Custom rear bumper -Warrior product tube doors (summertime) -Optima redtop (starter) -26XK miles and still runs like a bat out of hell

Kenwood H/U

1/0 wire,

136 amp alt 200 ah batteries 12.7 daily

2 Apsm 1500 @ 2 ohm strapped on zv3 d1 with ns softparts

Mb quart 125.4 wired to 4 aura 6's

3.6 cube box tuned to 36 plays down to 23hz

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 1387 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...