2k1 EM2 Civic >> PaCiFiKbAllA'z Update >>Wolfram Audio 4500.1 >>Singer 250A Alt>>Fi Audio SP4 V2 12" D2 FULLY LOADED!!

[PaCiFiKbAllA]

44 minutes ago, Smoove said:

have you been on the wolfram fan FB page. A local guy running 4 4500's. Colin ran 2 last weekend at a show.
I havent seen any on here yet.

I just checked it out...some dude just ordered 8 4500’s he’s gonna run one to each SP4....looked like 15’s but it might be 18’s...a lot of people snatching up Wolfram though ?

[Smoove]

1 hour ago, PaCiFiKbAllA said:

I just checked it out...some dude just ordered 8 4500’s he’s gonna run one to each SP4....looked like 15’s but it might be 18’s...a lot of people snatching up Wolfram though 

Thats a Vegas build, I cant wait to get up there to hear it.
Jake Varvel is doing a wolfram 4500x4 per 18" omega
Got a buddy in Georgia just ordered 4 to put on 4 sp4 18's

those amps are going like hotcakes.

[PaCiFiKbAllA]

Final components arrived (cept for the Ampere Audio Vibraflex Dampener). The goal is to be slumpin’ by this weekend.  BTW, the picture of the Sky High 4/0 gauge wire cutter is deceiving as fuck! ? it looked like a full size bolt cutter in the picture on the website. I love the small form factor!

[PaCiFiKbAllA]

Oh lookey what we have here...fuse box location is pending

I didn’t grab a pic, but I have the amp raised up on 1/2” square rubber spacers to allow better airflow and efficiency from the fan in the amp

Gotta keep it level man 

Jims Machineworx 8ga to 8ga reducers

Tightened up the sub wiring a bit

 

Next few things left to do is size and cut up my 0ga wire and install the XS Power batteries.  Almost there!

[PaCiFiKbAllA]

My shelf aka work bench

[PaCiFiKbAllA]

Priorities my boys...gotta get shit done!

 

My poor Stinger batt...had a good run...time for the big boys to play!

[Joshdashef]

On 5/3/2018 at 8:40 PM, PaCiFiKbAllA said:

Where did you get the rubber to mount your amp to the box like that from?

[PaCiFiKbAllA]

11 minutes ago, Joshdashef said:

Where did you get the rubber to mount your amp to the box like that from?

It was either Amazon or eBay.  Just search for “square rubber spacer”.  

[PaCiFiKbAllA]

Well alrighty then...just gotta connect up the grounds and front breaker and battery and were good to go...but before that, check out the progress pics!

[PaCiFiKbAllA]

Battery is not in its final resting spot.  Negative wire was test fitted and will be trimmed and zipped.  Otherwise the trunk is done (minus the fuses).

All that’s left is to connect the front breaker and mounting down the front battery (which will be done in a few hours) we almost there!