covi1234 Posted June 26, 2013 Author Report Posted June 26, 2013 Pos.... 2 1/0 cables. 2 4 Guage cables. Neg..... Is fine. The problem I have is I have to many wires on the Gm side mount extender that I have. The nut goes on but in don't like that I only have a few threads. Make sense?
Sutliff Posted June 26, 2013 Report Posted June 26, 2013 In 2012. I believe it was HalfPriceCarAudio.com, but you can find (Kicker) stuff almost anywhere. SonicElectronix.com, eBay, Amazon. Just do not forget to purchase the corresponding lugs for the terminals to be "attached"/tightened onto ... usually from the same company like I did. There are a PLETHORA of manufacturers that make them ... find the one(s) that suit your needs & possible future upgrades the best. Also, Darvex.com. Zeke '14 2003 Chevy Monte Carlo SS Vehicle Details & Mod List: http://www.stevemeadedesigns.com/board/garage/vehicle/1703-chevrolet-monte-carlo-ss/ Audio Build Log: http://www.stevemeadedesigns.com/board/topic/143276-2003-chevy-monte-carlo-ss-audio-build-ib-build Pioneer FH-P8000BT Infinity Kappa Perfect 6.1 Fi IB3 (Two 12", 2-ohm SVC) RF T400-2 & T500-1bdCP MechMan S Series 240A XS Power D3400 & D975
Sutliff Posted June 26, 2013 Report Posted June 26, 2013 Yeah, ... going to be my problem soon, too. I am looking into some custom made ones ... These are one 1/0 or 4awg & two 4 or 8awg outputs. I am going to need two 1/0s & one 4awg. I contacted ProjectDB. No response from e-Mail yet, but that was yesterday ... But I do not know if they make them with protectors included, will need one for POS side, & wand one for NEG side ... http://www.teamprojectdb.com/ Zeke '14 2003 Chevy Monte Carlo SS Vehicle Details & Mod List: http://www.stevemeadedesigns.com/board/garage/vehicle/1703-chevrolet-monte-carlo-ss/ Audio Build Log: http://www.stevemeadedesigns.com/board/topic/143276-2003-chevy-monte-carlo-ss-audio-build-ib-build Pioneer FH-P8000BT Infinity Kappa Perfect 6.1 Fi IB3 (Two 12", 2-ohm SVC) RF T400-2 & T500-1bdCP MechMan S Series 240A XS Power D3400 & D975
Amart88 Posted June 26, 2013 Report Posted June 26, 2013 I'm pretty sure it just takes a 3/8 bolt. You could get by by picking up 2 stainless 3/8 bolts that are longer. That's what I did before. My 2005 s10 blazer build. 4 zcon 18's walled.
covi1234 Posted June 26, 2013 Author Report Posted June 26, 2013 I don't know why in didn't think about that. Bolts would be perfect. Maybe make something when I'm bored out if aluminum.
lolitskasey Posted June 26, 2013 Report Posted June 26, 2013 for my GM i got the die hard AGM dual post group 34. So you can use the side posts for the stock and use the top posts for your power wires.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.