need some advice. deciding to do a cut through on a truck.

[imistm2]

Miguels I was thinking of taking it to a shop here in fresno. Thats the reason why i havent attempted it i dont want to spend money on material just to fail. The part i dont get on a ported box is the length and width of the port that needs to be built.

[will77530]

where are you located

[Miguels]

if you are having the shop do it why worry about the length and width? post dimension and people on here will help design it. you just have to build it.. you wont fail

[imistm2]

Will77530 in fresno,ca

Miguels well id rather build myself but i havent had much feed back on here. My max dimension to play with are (38"W x 9"L x 18" H)for a wedge box.

if i were to do a center console (9"w x 26"L x 18"H)

[bcbrassard]

BS...You just had a thread on here the other day and got a lot of ideas, suggestions & help. Man up and build a box for center console.

[imistm2]

Bcbrassard i have a sketch i needed help with doing an aero port the box i sketched has about .76ft3 but idk if this is correct from my math so if i have a 3"pvc pipe about 18" id be able to tune that box to 35hz. The dimensions are (9"L x 23"W x 16"H)

[imistm2]

And for a center console (7"H1 x 20"L x 18"2 x 10"W) then of course the slant that came about 1.1ft3 and again i would to calculate the aero port.

[will77530]

i manage a shop in sacramento im sure we can make whatever you want fit, message me your budget and we

ll go from there

[tacomaguy1]

Check out Audio Innovations on Ashlan and the 41

[imistm2]

Tacomaguy1 i went to them and well the guy there wanted to make me a sealed enclosure that kind of put me off.