4 channel going into protect mode?

[escottl92]

I have a AAK-180.4, checked power wire but every time I turn on it goes into protection, anybody have any advice?

thank you

[Mike4068]

Check your speaker wires. 

[escottl92]

Thank you I will check

[AaronT]

What's it running?

[escottl92]

Deaf bonce super tweeter 25 and deaf bonce Arnold mids

[Kyblack76]

take the load off the amp and turn it back on.... report back

 

[escottl92]

I will do that tomorrow 

thank you

[AaronT]

7 hours ago, escottl92 said:

Deaf bonce super tweeter 25 and deaf bonce Arnold mids

As mentioned above , after you do remove speakers, take an impedance reading of both mid ranges and tweets.  Make sure nothing's blown and coils are reading correct.

 

I had a speaker for lack of a better word "partially blown" or "on the verge of blowing" that's would give a weird creeping inconsistent impedance. I was able to hear it acting up when it did. Never stopped playing but it was F'd 

[escottl92]

I will do that tomorrow 

thank you

[escottl92]

Disconnected speakers still does it