Jump to content

Recommended Posts

I will send $40 to anyone who can tell me how to reset my Airbag light that keeps flashing in my instrument panel.

It's a 2006 Nissan Altima...YES, I disconnected the plug for the passenger light under the climate control and I know thats it needs to be reset now. (I was installing the Alpine processor that dcexplorer asked me to "Take a second" to install to see if it worked...in my rush I forgot you can't unplug that lite)

Already tried disconnecting the battery...that didn't work.

If you can tell me how (Other then telling me to go to the dealer..errrr) AND your method works I will shoot $40 into your paypal account. :8)

Disconnected lite under these controls.....

IMG_0359.jpg

Now this lite contiually flashes....

IMG_0358.jpg

Link to comment
Share on other sites

Worth a try but am unsure if it will work.....try taking it to advance auto and have them read it with the OBDII reader and see if it throws a code and if it does just have them clear it.

Vehicle: 1997 S10 Blazer 4dr 4X4

Exterior: Rear End Bagged, Black Grill, Lifted 2"

Amplifiers: Rockford Fosgate T8004 & T10001bd

Batteries: 2 Stinger SPV35, Kinetik HC2400

Electrical: Big 3, DC Power 290amp Alternator w/ MLA at 15.5v

Enclosure: 4.2 ft³ @ 33Hz 84sq.in. of port (20sq.in. per cube)

Headunit: Eclipse CD3200 w/ 80G iPod

Mids/Highs: Rockford T152s (a-pillars), Rockford T162s (doors)

Subwoofers: 1 15" Fi BL Fully Loaded

Wire: All 1/0g Kicker Hyperflex

My YouTube Videos

My Fiberglass A-Pillar Build

My "Seamless" Looking Box Build

My DD1508 T-Line Bandpass Build "Seamless" w/ Acrylic Windows (for '05 TrailBlazer)

My Stealth 8" Fiberglass Build (for '05 TrailBlazer)

My Build For A Friend's '08 Cobalt 15" BL Sealed Off From The Trunk

My feedback/references...

Link to comment
Share on other sites

1. Turn the key from off to on.

2. Watch the airbag light closely. It will stay on for a few secs. and then as soon as it blinks off (the start of the flashing), turn the key off instantly.

3. Count to 5 (1 Mississippi, 2 Mississippi . . . .)

4. Repeat steps 1-3 two more times until you have done the cycle three times.

5. Now turn the key on and watch the light. It will start blinking in a different, slower manner. This is diagnostic mode. You can watch this for a little while, no hurry.

6. Now turn the key off again, Count to 5 like in step 3 again, and turn back on. If the procedure worked, the airbag light will not be flashing.

If it does not work the first time, just repeat the steps again.

no bs either try it

Edited by troy

retarded build on the way.....

2000 bagged s10

2 hdc3 15s

aq2200

aq4x90

stinger/knu wire

optima batteries

220 amp alt

fosgate hu/mids and highs

Link to comment
Share on other sites

un hook the airbag light ftmfw!? :01nocomment8so: :unknw: :tease: :8)

here's a link to my system 99 toyota tacoma , 2 mtx 8000 1504's in a sealed downfire , 1000w memphis amp

here's a link to my other system my 90 geo prizm test car

heres a thread i got of new songs u can dl that are legal = Some Good Bangage/you Can Dl These Free And Legit

redblob.gifbouncing%20blob.gif2yooj7m.pngmodel14.gif

Link to comment
Share on other sites

TJ, try disconnecting the batt and letting it sit for about an hour, then re connect.

Actually swapped my battery out the other night and my ground didn't reach the new battery post (Odyssey 2150) so It was disconnected for about 12 hours until I could run a new ground. Thanks though.... :8)

Link to comment
Share on other sites

1. Turn the key from off to on.

2. Watch the airbag light closely. It will stay on for a few secs. and then as soon as it blinks off (the start of the flashing), turn the key off instantly.

3. Count to 5 (1 Mississippi, 2 Mississippi . . . .)

4. Repeat steps 1-3 two more times until you have done the cycle three times.

5. Now turn the key on and watch the light. It will start blinking in a different, slower manner. This is diagnostic mode. You can watch this for a little while, no hurry.

6. Now turn the key off again, Count to 5 like in step 3 again, and turn back on. If the procedure worked, the airbag light will not be flashing.

If it does not work the first time, just repeat the steps again.

no bs either try it

this will work ive done it before myself

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 780 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...