sundownz Posted August 18, 2009 Report Share Posted August 18, 2009 (edited) PRE-SALE ORDERS ARE FINAL - THERE WILL BE NO REFUNDS -- If you are not 100% sure you will be financially stable then don't pre-order. No more exceptions. These amps are capable of a real 1500+ watts at 12.8 volts. They will out-perform many other 1500 watt rated amps (like the Audiopipe 1500) easily! ETA is the end of November. As always with a pre-sale there can be delays! COST ON PRE-SALE : AUGUST - $250 each SEPTEMBER - $260 each OCTOBER - $270 each NOVEMBER - $280 each PRICE IS SHIPPED IN CONTINENTAL 48 STATES. CONTACT ME ABOUT AK, HI, and international !!! The earlier you pre-order the lower the price will be. REGULAR price will be $350 MAP / $549 MSRP when in stock! PAYPAL me at [email protected] to take advantage of the pre-sale offer. Pre-sale will be closed on November 15th ! ---------- Externally it will look just like the old model SAE-1200D : Specs are also rated the same : SPECIFICATIONS: * 1200 x 1 watts @ 1 ohm * 600 x 1 watts @ 2 ohms * 300 x 1 watts @ 4 ohms * 0.153v - 5.6v adjustable input sensitivity * 15 Hz - 250 Hz Frequency Response * > 90 dB S/N Ratio * 4-Way Protection Circuit (Thermal, Overload, Speaker Short, and Over Current) * 50 Hz - 250 Hz adjustable 12dB Low-Pass Crossover * 15 Hz - 50 Hz adjustable 12dB Subsonic Filter * 0 or 180 degree adjustable phase switch * 0 - 12 dB adjustable bass boost with 60 Hz center frequency * Wired Remote Control unit included * 5x 30 Amp Internal Fuses * 17" L x 10.6" W x 2.2" H BUT the board is ALL NEW in design : Updates : 1) Double sided PCB board (v.1 was single sided) 2) More primary input caps 3) Large brass bars for power supply current 4) Revised layout 5) Superior Soldering and assembly quality TESTING vs. similar board to Audiopipe 1500 / 1800 : http://www.soundsolutionsaudio.com/forum/i...mp;#entry546813 Edited September 29, 2009 by sundownz - Jacob Fuller - Owner, Sundown Audio - Sundown Audio on FACEBOOK - Please DO NOT PM ME -- use my email address -- [email protected] Link to comment Share on other sites More sharing options...
15VmaxXL Posted September 16, 2009 Report Share Posted September 16, 2009 Has anyone done testing with running these at .5 ohm? Doug sold everything Link to comment Share on other sites More sharing options...
k3n12ock Posted September 16, 2009 Report Share Posted September 16, 2009 If I can sell my ap15001d I will pick one of these up for sure! 05 xB - (2) EVIL 18s - (2) BC3500s - NO WALL Channel 1: http://www.youtube.com/k3n12ock Channel 2: http://www.youtube.com/MrK3n12ock2 Link to comment Share on other sites More sharing options...
sundownz Posted September 16, 2009 Author Report Share Posted September 16, 2009 Has anyone done testing with running these at .5 ohm? Doug I have - I don't suggest it long term on this amp. If you want to try 1/2 ohm get an SAZ-1500D. - Jacob Fuller - Owner, Sundown Audio - Sundown Audio on FACEBOOK - Please DO NOT PM ME -- use my email address -- [email protected] Link to comment Share on other sites More sharing options...
77-AUDIO Posted September 21, 2009 Report Share Posted September 21, 2009 So what will this amp put out at 14.6 PPI dbl dinDC Level 31.77cubes net tuned to 33htz.DC audio 2.0kCT Pro Audio 8" in front, 6.5 in rear Link to comment Share on other sites More sharing options...
jizazz12 Posted September 21, 2009 Report Share Posted September 21, 2009 currently i have two lvl 4 15's with a J.L. audio 1000/1 on each what would the real time power gain be if i were to swap out amplifiers ? 2007 Chevy Impala LS 1 Crescendo 3KWP 1Crescendo C1000/4 2 DC lvl 4 15's with lvl5 dual .7 coils 1Audio Control Matrix 1 Pioneer P880PRS 1 300 amp Iraggi alt All power runs done with Knu flex 0/1 guage 1 optima yellow top under the hood 1 XS 5100 and two Deka's in the trunk 4 Crescendo MP-8 mid bass drivers 2 DB Drive p5 5 D Pro Audio tweeters Link to comment Share on other sites More sharing options...
sundownz Posted September 22, 2009 Author Report Share Posted September 22, 2009 So what will this amp put out at 14.6 A bunch - more than 1500. - Jacob Fuller - Owner, Sundown Audio - Sundown Audio on FACEBOOK - Please DO NOT PM ME -- use my email address -- [email protected] Link to comment Share on other sites More sharing options...
sundownz Posted September 22, 2009 Author Report Share Posted September 22, 2009 currently i have two lvl 4 15's with a J.L. audio 1000/1 on each what would the real time power gain be if i were to swap out amplifiers ? Probably around 50% more. - Jacob Fuller - Owner, Sundown Audio - Sundown Audio on FACEBOOK - Please DO NOT PM ME -- use my email address -- [email protected] Link to comment Share on other sites More sharing options...
alphasig293 Posted September 22, 2009 Report Share Posted September 22, 2009 Damn I have 3 jl 1000's I wish I could sell and then buy 3 of these 2005 Lariat F-150 On 30 inch DUBS 6 Crossfire XS-V2 18's 2 Cactus 12k's, 1 Cactus 1000, 1 sundown 100.4 12 - 6.5 Crescendo mids and 4 Crescendo supertweets SMD 340 alt, Mechman 270 alt 7 NSB 170 batterys Link to comment Share on other sites More sharing options...
sundownz Posted September 22, 2009 Author Report Share Posted September 22, 2009 Depends on your impedance -- if you have W7 12s you have a 3 ohm load, so the 1000/1 is better for you. If you have a 1 ohm load that is where the 1200D v.2 will gain you. - Jacob Fuller - Owner, Sundown Audio - Sundown Audio on FACEBOOK - Please DO NOT PM ME -- use my email address -- [email protected] Link to comment Share on other sites More sharing options...
Recommended Posts