Carnag3 Posted June 10, 2010 Report Posted June 10, 2010 So I have noticed that one of my speakers is moving a little more than the other (longer excursion) and can't figure out why. I am running each sub off its own amplifer and have the gains set to exactly the same voltage output and the bass boost both on 0 and the subsonic both at 25. The suspension on both feel equally stiff and both coils are good. Any Ideas? For current setup, check sig. EDIT: Swapped wires from subs to opposite amps, results page 3 2000 Blazer 4dr -24" Boss 330s -Lowered 2/3 -5000k Hids w Projector Retro -Candy tails -LED interior lighting -20% tint 35% windshield -Alpine 9886 HU -RF P1462 Dash -RF P1652 Front -RF P1652 Rear -Two 18" Fi BTLs -MB Quart Onyx 4.80 -Two Audioque AQ2200Ds -Xs Powerr D5100, 2 Powersafe G31s -Knukoncepts 1/0 wire -Mechman 270 Alt w Boost Module -10.4 Net @ 28hz 140sq.inch of port My Youtube Channel!!
Autruche Posted June 10, 2010 Report Posted June 10, 2010 Have you tried switching the connections? as in hooking sub 1 to amp 2 and sub 2 up to amp 1? I would try that, then you'll know if it's a sub issue or an amp issue. Need Test Tones/Sine Waves? Click Here!My Saab 9000 build1993 Saab 9000 Aero 5spdPioneer - Zapco - Hifonics - Sundown Audio - O2 Audio - RE AudioJust Say No To Rear SpeakersJust Say No To CCA WireReal Men Drive StickHit me up on Facebook, if you want
Carnag3 Posted June 10, 2010 Author Report Posted June 10, 2010 different ohm loads. Negative, they are both D2's and are wired the same. 2000 Blazer 4dr -24" Boss 330s -Lowered 2/3 -5000k Hids w Projector Retro -Candy tails -LED interior lighting -20% tint 35% windshield -Alpine 9886 HU -RF P1462 Dash -RF P1652 Front -RF P1652 Rear -Two 18" Fi BTLs -MB Quart Onyx 4.80 -Two Audioque AQ2200Ds -Xs Powerr D5100, 2 Powersafe G31s -Knukoncepts 1/0 wire -Mechman 270 Alt w Boost Module -10.4 Net @ 28hz 140sq.inch of port My Youtube Channel!!
Carnag3 Posted June 10, 2010 Author Report Posted June 10, 2010 Have you tried switching the connections? as in hooking sub 1 to amp 2 and sub 2 up to amp 1? I would try that, then you'll know if it's a sub issue or an amp issue. Good idea, I'll do that in a little bit and post results. I have not been too fond of these AQ amps since I got them. 2000 Blazer 4dr -24" Boss 330s -Lowered 2/3 -5000k Hids w Projector Retro -Candy tails -LED interior lighting -20% tint 35% windshield -Alpine 9886 HU -RF P1462 Dash -RF P1652 Front -RF P1652 Rear -Two 18" Fi BTLs -MB Quart Onyx 4.80 -Two Audioque AQ2200Ds -Xs Powerr D5100, 2 Powersafe G31s -Knukoncepts 1/0 wire -Mechman 270 Alt w Boost Module -10.4 Net @ 28hz 140sq.inch of port My Youtube Channel!!
PUNKYOU007 Posted June 10, 2010 Report Posted June 10, 2010 I'll take em. Doethepaperboy "Bars of Pain" Doethepaperboy "Hero Remix" C. Arson d(-__-)b beer sucks...but i can bring some jose cuervo. Only problem is that it makes me horny and gives me the rams. So unless yall wanna fight and then have some great make up sex i will leave it home.
kandiman71874 Posted June 10, 2010 Report Posted June 10, 2010 Are both subs equal distance in all aspects to the port mouth in the box? if they are staggered you may have an unloading issue... Daily Driver 1999 Kia Sephia Kenwood DNX-893s Audison Bit One Processor 2 Dat 4.125's Sundown Audio SCV-6k Hertz hsk-165xl's Mids running active Focal V30 Series Tweeters running active Sundown Sa-8 v1's in the doors 2 Sundown Zv5 12's Lots of Hushmat Big 3+ and 3 + & 3- runs of Trystar 2/0 2 Dc Power Engineering 320 HP Alts 2017 Comp Vehicle 2006 Toyota 4 Runner Kenwood Excelon DNX-893s Audison Bit One HD DSP 4 Sundown Sa 6.5v2 Component Sets Focal Access 6.5 2 ways Sundown Audio Sax-50.4 Sundown Audio Sax-100.4 2 Dc Power 370xp Northstar agm27f Northstar agm65 2 Northstar asmagm 480's 2 Dual 1 Sundown Nightshade v3 12's 2 Sundown SCV-7500's All SMD Fuse Holders Shitload Of Sundown 1/0 120 sq ft Second Skin Damp Pro No, Its Not A Burp Truck!!!! 2016 Season 3rd place in Xtreme 1 At Finals 2016 Season 6th Place In Kaos 1 At Finals ( Blew The Subs Up In First Round Eliminations) 2 Kansas State Records Set In 2016 In Xtreme 1 And Kaos 1 In Midwest SPL David said: audio is a lifestyle, not a hobby newls1 I cant read a tape to save my life... 1/2's are ok, but other marks confuse me kingsuv only men who cant read a tape, take it in the ass kingsuv you sir, get a pink hard hat on jobsites
cracker Posted June 10, 2010 Report Posted June 10, 2010 Are both subs equal distance in all aspects to the port mouth in the box? if they are staggered you may have an unloading issue... was just thinking the same. edit-if its the same box in you youtube page then scratch this idea lol ports are centered March 2010 SOTM winner my old buildhttp://www.stevemeadedesigns.com/board/topic/50219-dank-aka-crackers-bonne-new-v2-build-in-the-works-hahahaaaaaa/page__hl__crackers my youtube page - http://www.youtube.com/profile?user=jackiedan04#g/u my feedback - http://www.stevemeadedesigns.com/board/topic/56540-official-cracker-feedback/ i need tacos and bass to live!!!!! and will NEVER change hahaaaa TEAM NOIZE VIOLATION
Freshman6969 Posted June 10, 2010 Report Posted June 10, 2010 sounds like a blown sub? or a coil Legal TL scores145.6 on the dash sealed up in the low 40hz area with the port out145.5 on the dash sealed up @30hz with the port inless then 1k clamped on a 3.5k! Why would you EVER WANT flex?huh?...flex is what can make the lows lower and more air being pushed correct? My FeedbackJeep-BuildlogPT LOSER buildlog
Recommended Posts
Archived
This topic is now archived and is closed to further replies.