Can plastic and wood be glued together?

[Tek]

I had to make a little mount for my Stinger Voltmeter, as there wouldn't be anywhere else to put it. My question is; can I connect plastic and wood together without screwing?

[Alex K]

if its 2 flat surfaces, sure. I'd use some wood glue, and plastic epoxy.

[Autruche]

impact tough gorilla glue, it sticks to almost anything, as long as there's enough surface to glue, I only suggest that cuz I'm guessing you just want something cost efficient. although, I have used it on wood and plastic, but never tried to glue wood to plastic.

[jmitch]

yeah use that 5 minute epoxy it works i did it to make a bracket for my hu and eq and its still strong

[mbdblue]

impact tough gorilla glue, it sticks to almost anything, as long as there's enough surface to glue, I only suggest that cuz I'm guessing you just want something cost efficient. although, I have used it on wood and plastic, but never tried to glue wood to plastic.

gorilla glue is good, but it is one of the expanders...it expands like foam when it hardens....

to the OP.....CA glue loves to never come off.

[Tek]

alright I'll explore all of these options and see what the most practical is. Thank you for everybody's input.

[speedball1978]

What the heck is CA glue i've been seeing this all over the threads.. mind telling me what CA stands for?? unless its cement adhesive (cement glue)??

[BeatBox]

CA=Cyanoacrylate Glue

where are you putting the volt meter at?

[Tek]

CA=Cyanoacrylate Glue

where are you putting the volt meter at?

a cubby hole in my dash.

[BeatBox]

oh nice, i cut a hole and pushed it thru no glue...it just tight enough that it wont pop or anything.