fox_racin4

When you get it installed, get a vid of his reaction!!

Remember, your CURRENT springs are worn out.. they may be shorter then they were when you first got the cae

No spring compressor needed put car up on jsck stands ( on frame not rear axel) Put jack under rear axel and lift axel up a bit so its not just "hanging"there Loosen shock bolts Lower jack and your springs will come out

Pull it out, i took mine out in 10 min, loosen shocks drop axel springs will fall out.

IMO way to much for that... just needing a braket, i have the alts but no braket!

hey guys, im needing an alt braket ( or template i can trace out) for a 1998 GMC 1500 5L 2wd lemme know whatcha got!

U mad?

Sa10s, mine have been awsome! i need more power on them still too!

3/4 of the shops dont know how to PROPERLY build a ported box

2 15s would be tight, what are your max demension?

You cannot fit 2 18s into a trunk if it was sealed they would still be a tight squese you will beable to get louder with a pair of 12s or even 4 10s

once all amps are shipped can you PM me how many dc5.0s are left please?

uhhh if you have d 1.4's you will be at .7 .7 coils will get you .35 Hes got 2 subs, 1.4ohm coils will get you .35 and 1.5ish i think

If you need shipping help LMK ,

sorry for the thread jack here.. but this fits in to the off topicness i had a guy tell me he was going to do a 180db, because he had the same subs the pioneer truck had what it did a 180db was an interesting convo..

Nice! That's the exact setup I will be running to each of my Lv 5s. so youll be doin 300db ya? hahahah..

hoping to place my order soon!!!

But red symbolizes "stop" or "bad." yes.. but hte red is hard to see in the day light and the blue light is to damn bright!!! lolbut yea the gain knob at max setting is the max you have the amp set too, i have a AQ2200D and asked this same question a few months back yes.. yes it is i had to put tap over mine.. the blue IMO shoul dbe for clipping.. much easier to see in the day, and much brighter

The one thing i hate about AQ bass knobs is they are backwards... and i think the blue LED should be clip indicator not the red one

here you go.. Secure Video

Yes i seen that lol, but its not possible lol

There 2ohm svc, no way to wire them differntly unless the one wasnt hooked up..

Yup! lol for being a small box ( .8per sub) and not much power to subs (600rms at best) it gets low and loud, i will be adding 4 more (maybe 6 more) and doing a wall, tuned around 30hz and amps will most likely be 2 DC5ks this is just the beginning!!!

Before I extended port it was doin a 146.9 on an aq3500 not sure what its doing no

Herea a short vid of the current setup, Box is 6.5cubes at 34hz amp is a cresendo running at .5 8 sa10s Not the best vid, but it works! the back window needs some attention, as well as the roof